0
When you start the engine you can put it into gear without pushing the clutch pedal what is the fault?
Wiki User
∙ 9y ago
Assuming the vehicle doesn't move when you put it in gear, it sounds like the clutch is blown.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What makes an engine stall?
bad driving technique a clutch fault a misfire in the engine and having your bite point too high or releasing the clutch to quik
What is the diagnostic code P0645 on a 2003 Dodge Grand Caravan 3.3 liter engine?
OBD P0645 indicates a fault in the A/C clutch relay.OBD P0645 indicates a fault in the A/C clutch relay.
Your car is a 2003 Ford Mustang Standard shift at times when driving or parked you will here a squeak in the front of the car when pushing upward on the clutch it stops what causes that?
The release bearing on the clutch is at fault. Throwout Bearing, replace the Throwout bearing and check the Fork for Damage.
What type of fault is convergent boundary?
A convergent boundary is a reverse fault. It's a reverse fault because it it pushing together, while a divergent boundary is a normal fault because 2 plates are pushing away from each other.
What type of fault is a convergent boundary?
A convergent boundary is a reverse fault. It's a reverse fault because it it pushing together, while a divergent boundary is a normal fault because 2 plates are pushing away from each other.
Why does your Peugeot 207 clutch pedal stick down?
Fault with clutch master cylinder.
Why is Car reving and not going into gear?
Fault with the clutch probably.
Can clutch replacement cause wheel bearing fault?
not if you re pack the bearings!
Why is the Air conditioning pump not working on Vauxhall Astra?
Possible causes could include: Failed air-con on/off switch. Wiring fault. Compressor clutch fault. Blown fuse. No gas in system. the clutch on the compressor has a fuse and it was blown. i soldered across the fuse and the clutch is now working. also if there is not enough gas the clutch will not engage as well.
What is a reverse fault in science?
The crack or line between two plates that are pushing together.
What could be the problem on a manual 2001 civic when one comes to a complete stop it dies?
This indicates that most likely the clutch is not being fully disengaged. If you are pushing the clutch pedal fully, you should check whether the brake fluid cylinder for the clutch contains fluid. If it is low, you most likely have a leak. It should be topped up only with the appropriate fluid, either DOT 3 or DOT 4 in most cases, and under no circumstances should water or oil of any kind be allowed to enter the system. Even if the fluid is good, there could be mechanical problems with the clutch. I recommend inspection by a trained mechanic. If it is not a clutch problem (you should also hear noise shifting gears if the clutch is at fault), then it may well be a computer issue. With the clutch disengaged, there should be no connection between the wheels and the engine, meaning that forward motion is irrelevant to the engine running. That means the only connection can be in the control electronics. Unfortunately, you probably have to go to a Honda dealer if that's the case.
How much costs for service engine soon BMW?
you need to have the check engine/service engine soon fault codes read to determine what the fault is.
