Grand Am SE

Where are the Heater hoses 1995 Pontiac Grand Am?

91011

Top Answer
User Avatar
Wiki User
Answered
2013-12-10 17:33:31
2013-12-10 17:33:31

I have antifreeze coming out of the bottom of my 1995 Pontiac grand am in the middle of the frame just below my front end is this from the heater core?

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


The heater core is located under the dash board, all you have to do is disconect the heater hoses then unbolt the consol and slide it back far enought to be able to unbole the heater core and slide it out. The install is just reversed from removal. Joe


it is located behind the dash. an you have to take the dash apart to get to it


The heater blower motor itself is located under the hood on the passenger side of the car.


where is the headlight relay in a 1995 grand am


where is the heater core for a 1992 bonniville


Were is the fuel filter on a 96'pontiac grand am


Where is the motor mount located on 1995 grand am


The 1995 Ford Escort series of vehicles have a conventional heater core design and location. The heater hoses through the firewall are on the right-front (passenger) side of the vehicle.?æ


The heater blower motor in a 1995 Pontiac Transport is located on the passenger side of the engine compartment. It is on the firewall near the hood hinge.


GOOD CHANCE THAT THE WATER PUMP CRAPPED OUT.Replace the radiator cap. my car has 2 bleeders on the hoses get the air out


what is the correct alignment marks on a 1995 Pontiac grand prix


Fuse box for 1995 Pontiac grand am - door lock


1995 grand ams are not carborated .. they are fuel injected..


Could be the heater core leaking or the windshield needs sealant.




how many hours to remove oil pan gasket 1995 Pontiac


The turn signal relay for the 1995 Pontiac Grand Am is mounted above the fuse block. Look under the dashboard on the driver's side.


In the steering column, the grand am has a multifunction fuse box


They are on the backside of the engine and go into the firewall.jd


Just unhook the hoses from the heater core and put a tube are something in the middle of them and clamp them together.





Yes, but you may have wiring issues. Usually, it's not worth the hassle. Use the correct tranny.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.