The Freon recharge port can be found on the top of the air conditioner compressor. There will be two ports. The recharge port will be labeled as the low pressure port.
where is the suction recharge value on a 200 ford focus
The recharge is located right beside the radiator cap. There should be a green Cap on and it should be labeled AC recharge.
There are two valves on the air conditioner on a 2000 Pontiac Bonneville. Attach the hose that fits the refrigerant and fill that side.
Check your fuse boxes.
On passenger side, it is located on the aluminum looking can called the "Accumulator'.
how do you charge the air conditioner on a 2000 neon
The 2000 Chevrolet Silverado truck has two ports on top of the air conditioner compressor. You will add Freon through the low pressure port.
The low side ac port is on the passenger side of the car. It is made into a metal pipe running front to back, close to the fender.
Low pressure connector is at the front of engine below front exhaust manifold behind the electric fan for the rad....
Not sure what your asking yes you charge from the low pressure port it is the smaller one your hose should not fit on the high pressure side
The recharge port is located on the passenger side near the firewall.
I have a 2000 Ford Focus it uses Mercon V. Mercon V is what I use in my 2000 Focus with a standard transmission. I have an Automatic 2000 Ford Focus station wagon and the owners manual suggests Mercon V.
I attempted to refill the air-conditioning fluid and it had plenty of pressure... I'm not sure why the air won't get cold.
Yes, a 4.5 ton air conditioner would be the minimum size for 2000 square feet.
Program a new key and ignition to a 2000 ford focus
how to remove hub assbley from car 2000 ford focus
Where is the temp sensor on 2000 ford focus zetec engine
Indecision 2000 Focus on New Hampshire - 2000 TV SUSPENDED was released on: USA: 2 February 2000
you should be able to get a connector from a good motor spares shop,i.e. Halfords,that will plug straight into the back of your radio and into the connector on the car wiring harness so you do not have to cut into the wires
Yes, because the entire system de-pressurized when you added a new component to the system.
Freon administered into your ac unit!