There are 2 one on the bottom easy to see and access. The other is on the top hard to see and access. You will need about a 12 inch's worth of extension to make it easier. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For Information & Contact Details.
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
Disconect the - battery cable Raise and support vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
Remove wiring remove the 2 bolts holding the starter to the engine,remove the starter,you might want to remove the air filterhousing and inlet hose.
You should remove the positive cable from your 1996 Toyota battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
Remove the battery and the cruise control actuator. The starter has two bolts holding it in. Remove the bolts and wiring, then install the new starter. Re-install the cruise control and battery.
remove the neg battery cable then the wires on the starter. Then take out the mounting bolts and work the starter out.
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
The starter is located on the driver side of the under the intake maniford it has two bolts 14mm to remove it.
remove battery and tray, two, 17mm or 18mm bolts hold starter on. one on top of starter and one on bottom
Remove the positive battery cable from your 1997 Toyota Corolla battery. Tighten the starter with the retaining bolts. Attach the cables to the front of the starter. Reattach the positive cable to the battery.
Is this the airplane? Remove one battery post connector. Remove wire connections from starter. Remove mounting bolts. Remove starter. Clean the bolts and starter hole of any dirt or grease. Install new starter with cleaned bolts and reinstall wires and battery connection.
disconnect power from battery, remove wires connected to starter, remove bolts from starter (usually 2), remove starter.
Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Disconnect the - battery cableRaise and support vehicleRemove wiring harness at starterRemove mounting boltsRemove starter Disconnect the - battery cableRaise and support vehicleRemove wiring harness at starterRemove mounting boltsRemove starter
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
Turn of the ignition and disconnect the negative battery charge. Remove positive cable from the starter. Loosen the bolts that hold the starter to the block and remove the supporting brackets. Remove the bolts holding the starter. Remove the starter and place a new one.
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
disconnect the battery cables, remove bolts/nuts, remove wire, pull starter off, bingo~! put the new starter in, put the bolts/nuts back on, put the wire back on, hook the battery cables back up, bingo~! fire it up!!!
where are the two bolts located on the starter?
remove starter boltsremove cable and wires
Disconnect the negativebattery terminal, starter is accessible from under the car passenger side, it bolts into the transmission with 3 bolts. Disconnect the wires from the starter, remove the bolts and reinstall new starter, reconnect wires.
remove elec cables on front of starter/m then remove two bolts from face of starter/m then remove
Remove the battery cables. Remove the positive cable from the starter. Loosen all the bolts that hold the starter in place. Remove the starter from the car.