I don't know where specifically they would be (if there are any at all...), but on most of the engines I have worked on that have had them, they were in the engine block somewhere, with the intended purpose of a drain, not an air bleed. I don't think many modern cars (if any at all) have bleeder screws for coolant.
95 Cutlass service manual. Try Helm.
yes with full size cutlass not cierra
How do you replace a axle on a 95 holds cutlass supreme
The GM 4T60-E is the stock transmission on the 95 Cutlass Supreme.
They are not screws they are bolts either 1omm or 13mm
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
== == == ==
put brake fluid in reservoir and loosen the bleeder screws. step on the brake with the motor running and tighten bleeders before releasing brake pedal. repeat as needed
R134
Yes
May be located in the head nearest the firewall on the driver's side. That's where it is on my 95 3100.
Yes