answersLogoWhite

0


Best Answer

T bothsides.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where are the fusible links in a xh falcon ute?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where do you fill the water up in your Ford Falcon ute xh 1996?

In the water bottle.


1996 xr6 Ford ute?

1996 ford falcon xr6 ute is in the XH range. the XH's range is April 1996-1999. it is hard to tell exactly what you are asking but hope this helps :P


Xh falcon ute had a misfire at low rpm now it has no spark?

requires new coil & dizzy


How do you get to the petrol tank to fix a leak in an XH FALCON ute is the access under the plastic tub liner?

yes


Where is the horn located on a Xh Ford Falcon ute?

tucked in behind the front bumber bar. in front of the a/c condenser


When was Ford XH Falcon created?

Ford XH Falcon was created in 1996.


Where is the remote control sensor in a XH falcon ute?

i think your refering to the BCM or Body Control Module. it's located behind the dash near the hand brake.


Where is the transmission fluid dip stick in a ford XH Longreach ute?

It does not have one The automatic gearbox is out of the EL Falcon while the engine is carried over from the XG Longreach!


Where is the fuel filter on an XH Falcon utility?

the fuel fliter on 4.0 XH Falcon Ute is under L/H side of car near the sill roughly where the passenger seat is. make sure you use a good quality spanner on the fittings as the round easily. Pipe type spanners are best to help prevent this.


Is the air temp sensor on the back of the inlet manifold on a 97 xh Ford Falcon ute?

assuming it's the 4 litre. yes it is. hard to change on the ground. easy to get from under the car.


What is original color of 1998 falcon Ute 6cl longreach body control module what other models would also fit a 98?

a 98 xh longreachs bcm colour is grey with a black metal bracket,riveted to the case.


Where is the inlet manifold on a XH ford Ute 97?

open the bonnet, alloy part bolted to the R/H side of engine is the inlet manifold. NOTE: IF you need to ask this question do not attempt any maintenence yourself.