the headlight adjustment screws on a 1994-1997 Ford Thunderbird are found in a similar position to the 1987-1993 Ford mustangs. They are on the back of the headlights in the engine compartment. they too are also 4MM hex heads located between the radiator core support and the hedalamp itself.
Can you put a 1994 thunderbird motor in a 1996 thunderbird?
There is 2 large plastic screws that hold the headlight assembly`s in. Simply unscrew them and lift the headlight assemblies out then unhook take the bulbs out.
Remove the 4or5 screws along the top of the trim plate, the trim plate should pull off,the headlight switch is attached to the trimplate.
you have to remove to entire headlight assembly 2 screws on top and 2 nuts on the backside of assembly that go through metal panel
bolt pattern for a 1994 ford thunderbird
Remove the parking/turn signal light assembly. Take off the grill. Remove the headlight bulb. Remove the inner and outer attatching screws and upper attatching screw. Lift the headlight out.
A potential cause of bulbs burning out in cars is a dirty or corroded bulb socket, or a bad wire connections at the socket.
Check fuse for parking/tailights Check for an open circuit in the dimmer rheostat Could be a bad headlight switch Burned out bulbs?
unhook 6 black slide clips from top of grille, and 5 black slide clips from bottom of grille, and remove chrome trim screws (4) from headlight assembly and unplug headlight and swap it out. assembly is reverse of removal.
Standard tyre size for 1994 Ford Thunderbird LX 4.6L V-8 automatic is 205/70R15
I assume you are asking because you want to replace the bulb, so the answer that follows is to disassemble the headlight and reassemble it with a new bulb. 1. Remove the headlamp door attaching screws and remove the headlamp door. 2. Remove the headlight retaining ring screws and remove the retaining ring. DO NOT disturb the headlight adjustment screw settings. 3. Pull the headlight bulb forward and disconnect the wiring assembly plug from the bulb. 4. Connect the wiring assembly plug to the new bulb. Place the bulb in position, making sure the locating tabs of the bulb are fitted in the positioning slots. 5. Install the headlight retaining ring. 6. Place the headlight trim ring or door into position and install the retaining ring screws. This is quoted from Chilton's repair manual for the 1983-1994 Ford Ranger, Bronco II, and Explorer. I followed these directions and was able to replace the bulbs on my 89 Ranger. Good Luck!
bang