arnt all spark plugs just below the valve covers on all engines ???
They are right there on the top of the engine.
Right up under the tank.
how the sequence of spark plugs goes on the engine of 1990 Toyota cressida
Follow the sparkplug wires down past the valve covers -they should be at the end of each wire
The 2.3 liter 4 cylinder engine has ( 8 spark plugs ) , twin plug ignition system The 2.9 liter and 4.0 liter V6 engines have ( 6 spark plugs )
you are not getting spark. this could be from a bad alternator, bad spark plugs, bad spark plug wires, or bad engine coils. The spark plugs and wires are the cheapest so try putting in new ones of those first.
The only time I've seen cracked spark plugs was putting them in or taking them out with the socket not perfectly straight.
To replace the spark plugs on your Celebrity requires a 5/8" spark plug socket, short extension and either a ratchet or breaker bar. First remove the spark plug wire then use the socket to remove the spark plug. The spark plugs should have a .045" gap. Replace the spark plug and reattach the wire. Continue until you have replace all of the spark plugs.
check/replace spark plugs
They are sometimes called freeze plugs but in reality they are casting plugs. They are located on the side of the engine block.
Remove the plug wires by turning them on the plugs to break the seal then pull then off and unscrew the plugs and regap the new ones and reinstall them
According to one of Fords websites : A 1990 Ford Probe , 2.2L four cylinder engine has the spark plugs gapped at : ( .044 inch )
The spark plugs are hidden underneath the coils which are part of the spark plug cap for each plug. After you remove each coil you will see the plug deep underneath. The coils themselves are quite inconspicuous but you will find them if you look carefully.
a spark plug is something in your car that cntrlles it to move a spark plug is something in your car that cntrlles it to move i believe 0.35 you should be able to find this out on the catalyst sheet located on the fan shroud or right under the lip of the hood
According to one of the Ford websites : For a 1990 Ford Bronco 5.0 / 302 cubic inch V8 engine : ( the spark plugs are gapped at .054 inch )
Get a manual on your car from the parts store or DISCOUNTAUTOREPAIRMANUALS.COM
.044 inch ( according to motorcraft . com )
being a 1990 it may have a distributorles ign, find one of the spark plugs,and follow one of the wires back to the end. if it goes to a small black box, then it is a distributorles. There is no distributor. It has coil packs located underneath the front exhaust manifold.
THAT IS THE TRANSISTOR IGNITION UNIT WHICH SENDS OUT THE SPARK TO THE SPARK PLUGS AFTER THE COILS. IN THE EARLY Z32 300ZX'S, THERE WAS A RECALL TO GO TO NISSAN AND GET THAT CHANGED FOR FREE
This information should be on the fan shroud.
change distributor cap and rotor
Yes, but you'll have to pull the plenum first.
According to one of Fords websites : For a 1990 Ford Bronco II , 2.9 liter V6 engine : The spark plugs are gapped at ( .044 inch )
Standard gap is .060" or 1/16".Ask at auto parts counter when purchasing spark plugs.
I just tighten them with a regular spark plug socket rachet. You should be able to feel when to stop tightening.