On the top of the valva cover. The ruber boots that you have to pry off first. Two are uncovered and two are covered (see rubber circles): http://i11.ebayimg.com/02/i/07/5c/7f/a9_12_sb.JPG
Difficult to describe. It is next to the timing belt and is usually changed when you replace the timing belt
install a radio
I believe it is integrated with the fuel pump.
How To Replace 2003, 2004, 2005 & 2006 Mitsubishi Outlander Cabin Air FilterOE Replacement Cabin Air Filter Part No: MR398288http://www.youtube.com/watch?v=qY4MsDlepP8
where is the cabin filter located on a 2201 Mitsubishi galant and how do you replace it
It is located internally inside the Distributor
lower radiator hose
Passenger side, near the firewall. It is not difficult to replace, it is just very difficult to get to.
how to replace a mitsubishi endeavor battery
It is located on the passenger side firewall, under the hood.
I was told by Mitsubishi of groton that the fuel filter was in the Gas tank so there was no real need to replace it.
you need to drop the drive shaft, and rear axle to pull the gas tank out. don't forget to replace the fuel pump while the tank is removed.
how to replace bulbs on a 2009 mitsubishi eclipse
Horns generally can not be repaired but replaced. On a 2001 Mitsubishi Eclipse the horn is located inside the front bumper. To replace it disconnect the mounting bolts and remove it. Replace with a new horn.
How do you replace the timing belt on a 2003 Mitsubishi Lancer?
it is located on the left side of the front valve cover, where all the spark pug wires connect to....
catalytic converters are located near the muffler.very difficult to replace
How difficult is it to replace a 2000 Toyota Avalon window washer pump and where is it located?
I could be wrong, but most of the time tire monitoring sensors are found inside your tire on the valve stem, they send wireless signals to your on board computer. If you need to replace it, you can purchase the part from a dealer and replace the valve stem.
65,000??? Now would be good but you can go a little longer. I have seen many with 80,000. After that you are pushing the limit. Don't forget to replace the water pump at the same time (and the tensioner pulley too but not mandatory)
How to replace wiper motor on a 1998 montero sport mitsubishi
how do i replace a front crankshaft seal on a 99 mitsubishi mirage
its in the tank witch has to be droped
its easy to find, things like that are usually belt dirvin so itl be on the drivers side in the engine bay with a belt and pulley attached to it... experience and tools determine how difficult it will be.
The water pump is located on the passenger's side of the vehicle near where the engine belt is located (on a 3.3L engine). It seems to be a little difficult to get to. Have always had someone else replace my water pump don't know how difficult it is to replace.