speed sensor is located on the drivers side of the transmission about 10-12' from the very rearmost point. it appears as a barrel or cylinder shaped object about 1 inch around and 1 1/2 inch long or so with 2 wires coming out and about a foot of wire before a plastic plug in connector. it is held in place by 1 bolt which uses a 10 mm socket to remove it
On a 1987 Nissan Hardbody Pickup, the PCV valve is located between the alternator and the oil filter. The valve can be seen when the oil filter has been removed.
where is the pcv valve located 1994 nissan pick up 4wd 2.4l
1995 nissan pickup has a expansion valve rather than a orfice tube and is located on the evap.
below the right side of carb.
if I knew the answert I wouldnt be here!!
there are two a turbine speed sensor and an output speed sensor both are located above the valve body.
The valves in a 2.4 L Engine Are not Adjustable
In the ac box
insid ac box at floor board.
in back of the alt you can fill it but can not see it take alt out of way to get to it
first its an egr valve and its between the exhaust manifold and the exhaust pipe itself usually on the passenger side
The expansion valve is located in front of the evaporator core. You must remove the housing to access it.
EGR sensor ( gas temperature sensor ) is monted near the EGR valve, which is install into the EGR tube.
Is it a 12 valve engine or 24 valve? What do you mean by speedometer sensor? Do you mean Vehicle speed sensor? If so why do you want to change that?
It is bolted to the bottom of the throttle body.
the air intake valve is located on the side if your air cleaner/air box.
its located in valve body
PCV valve is located under the hood, center, upper engine area, mounted in intake manifold.
It is inside the trans, on the valve body on the passenger side
It should be down below where the slave cylinder connects to the tranny
None that I'm aware of, but you'll need to check with a Nissan dealership. I know I had a recall on my 96 XE, but that was for a valve in the fuel system.
On a lot of these vehicles, the PVC valve is located on top of the valve cover, or a hose leading from the valve cover to the intake. You have to remove the right front wheel. It will be in the block. It is in an awkward place and Nissan charges about a 100.00 to install it. You can do it your self though.
the cap is open
On the 1997 Nissan pickup its just above the oil filter, lower right of engine, access through right front wheelwell after removing wheel, it's a screw in affair.