Be the first to answer!
Yes, it can stop suddenly. You may not have a code set if it failed instantly.
Oxygen sensor 1. In exaust manifold.
If you are reading a code with the description "ambient temp. sensor open" that means that the sensor or the wiring to the sensor is open or broken. The sensor will have to be replaced or the wiring to the sensor repaired. Have it troubleshot prior to just throwing parts at it.
BCI code 40R type battery
O2 sensor or wiring
The code P0341 means that one or more of the following has happened. The cam sensor wiring may be too close to a spark plug wire causing interference, a bad wiring connection at cam sensor, a bad wiring connection at PCM, a bad cam sensor, or a damaged reluctor wheel.
www.the12volt.com has all factory wiring diagrams for free.
Sensor, wiring, or computer. Those are your three options.
Knock sensor/vibration sensor
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
You'll need to change the O2 sensor. Before replacing the O2 sensor be sure and check the wiring as that might be the problem. A short in the wiring or a loose wire will cause this code.
Happened to me to and need a crank sensor also!?
It is a code that says that there is a problem in the fuel level sensor. It could be wiring or a faulty sensor. TO repair remove fuel tank, inspect and repair wiring as needed. If no wiring fault found replace sensor, normally part of the fuel pump assembly. Some Fords are seperate parts
Check all your wiring for your map sensor, if ok replace the map sensor.
P= Powertrain 0140= bad oxygen sensor downstream from the catalytic converter. Check wiring first, if no problems with broken wiring replace sensor.
Generic OBDII code. P0114: Intake Air Temperature Circuit Intermittent. Solutions: *Check connection to Air Temp Sensor in air box. *Check wiring for frayed or loose wiring. *Replace Sensor.
The code refers to the front oxygen sensor on bank 1. That O2 sensor needs to be replaced or the wiring has come loose or is shorted out.
Trouble code P0117 means:Engine coolant temperature circuit low input
Throttle Position Sensor/Switch A Circuit Low Input You need to test the wiring to the TPS, check the computer, and maybe replace the tps
P0102 - Mass Airflow ( MAF ) sensor circuit low input
The downstream O2 sensor was broken and is missing the wiring harness, I have a universal O2 sensor, but need the color codes to wire it properly. It has a purple, pink, black and white.
problem is not sensor but is in wiring to sensor or computer
Trouble code P0135 means:O2 sensor heater circuit malfunction (Bank 1 Sensor 1)
Trouble code P0136 means:O2 sensor circuit malfunction (Bank 1 Sensor 2)
drivers side under dash near door