answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2009-07-15 23:59:47
2009-07-15 23:59:47

This is available from your local Kia dealer or you can also search the internet for many other retailers. Cardone provides a remanufactured one without the regulator.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The window is not off track. The window regulator is broken. In most cases you will have to replace the window motor and regulator as an assembly.


I recently had the same problem with a friends 01 Town and Country and it was the drivers side power window motor at fault. A Mopar mechanic friend of mine strongly recommended purchasing the power window regulator assembly with motor attached. If you separate the motor from the assembly, reinstallation is nearly impossible. The complete window regulator with motor assembly was just under $140. Installation took about an hour. Also, the dealership had the assembly in stock which tells me they sell many of them.


how to replace1994 grand drivers side power window motor


Unfortunately you can't just change the motor. You have to buy and replace the whole assembly including the window. Its a rip-off but the motor, ratchet, arms and window comes as one replacement assembly.


Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.


Remove the door panel. Remove the bolt that fastens the regulator to the window. Remove the 3 bolts that hold the regulator assembly to the door. Squeeze the entire assembly through the largest hole and replace with a new assembly in reverse order.


A switchThe window motorThe window motor fuse(s)See "Related Questions" below for more


The cable runs through and is coiled inside the motor. It is advised to replace as an assembly.


The window regulator assembly is not repairable, you will have to replace it if the metal wire has broken. Look on eBay they are around 40.00 for the whole assembly.


It's possibly the switch or the motor in the door. I have a 99 Nubira (Australia) and the window winder motor died. I got a 2nd hand/used one with the assembly and swapped it. Now it works fine! Jeff in Oz


How do you remove and replace the motor for the drivers side power window in a 2000 Sienna


i am assuming from your question you already have the door panel off. Sooo, the motor is part of the window regulator assembly. Now some are bolted on, some welded, and some riveted. You will have to drill thru the welds or rivets to remove motor. Once old motor is out go to hardware store and get some bolts,washers, lock washers and nuts to remount new motor. some kia sportages won,t let you do any of the above, you have to replace the whole motor cable assembly as a unit. If this is what your facing google the internet ,there are several window reulator companies and the pricing varies from $ 55.00 to $ 300.00. also there is a left and a right and NO they will not swap. I this is the method you have to use have a buddy to hold glass up while you change out unit. hope this helps.


The power window fuse for a Kia Sportage is located in the main fuse panel under the steering column. It is used to prevent the motor from drawing too much power or being damaged by a surge.


how to change lifter motor on kia sportage


Remove the inside door panel of your 1988 Lincoln Town Car. Remove the wiring harness from your window motor. Remove the window motor retaining screws. Reverse the process to install a new window motor.


i need a diagram to install a window motor on a 1980 gmc truck



You don't let some else do it. I say this from experience on a 2004 The motor is separate I used the old motor and replaced the regulator. I had to drill out rivets OH ya I BROKE the window drilling out the rivets that hold the window onto the regulator. after that I reattached the motor assembly with bolts and nylon lock nuts. then went to a glass shop to have the window replaced.


Buy a chilton's or haynes maintenance manual. They tell you everything. I had to replace my drivers side window motor. Not too hard.


undo the bolts that atatch the roll bars to the window on drivers and passenger side, the undo the bolts on lower window that hold the window to the tub on both passenger and drivers side. the window should now fold outwords onto the hood, once it is on the hood the wiper motor will on the drivers side window frame. remember to disconect the battery before any of the steps



Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly


If it is electric windows it is the motor which needs replacing or it could be the regulator



It's the motor assembly that causes the door to go up and down.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.