0
Wiki User
∙ 10y agoThere are several companies that can perform printed circuit board repair such as GoTronic and EY Technology in the UK. If the damage involved is small, one may also be able to find instructions for minor repairs from technology forums such as Tom's Hardware.
Add your answer:
Earn +20 pts
What are two sources that a circuit might use?
coil and oil
What might cause a breaker to trip when switching on a light when resetting the breaker and checking the fuse doesn't restore power to one circuit?
Overloaded circuit, short in circuit, or defective switch.
What happens when a solar cell cannot supply enough current to a circuit?
the circuit might not operate properly. but shouldn't effect the circuits them self.
An example series circuit might be what?
A voltage or current source in series with a circuit breaker or fuse in series with a switch in series with a light bulb.
Why high level language is slower then assembly language?
Programs written in a high level language might be slower than ones written in Assembly language; but it is not always so, it is very easy to write un-effective programs in Assembly.
How do you replace the wiper motor circuit board?
This is really an easy fix. The wiper motor assembly is on the firewall, just right of center. The wiring can be unplugged before the circuit board is removed, or afterward. I found it easier to unplug it after the circuit board was removed. There is a flat cover that is held on with three torx screws (T20). Remove those screws and remove the cover. The circuit board will now be visible. Remove the circuit board by grasping the wiring connecter and gently pulling it towards the front of the vehicle. When the circuit board has fallen free, unplug it from the wiring harness if you haven't already done so. The solder joints that connect the wiring socket to the board were bad on my board. I just resoldered those and re-installed the circuit board. I did get an entire wiper motor assembly, which included the board, from a salvage yard for $40. I didn't even use it. Excellent answer! My wipers would not start without getting out and helping, then they might or might not continue running after a few wipes. When switched on and not running, module would produce buzzing sound. Followed directions above, and even though the three pins joining the wiring harness plug to the circuit board looked properly soldered, carefully re-soldered making sure to have good solder contact to printed circuit strips. In my case this worked like a charm, and judging from the number of postings for this fix, it seems to be a common problem with this board. It would seem to be a good first step unless there are other obvious signs of failure.
What is the main board in any electronic device called?
A circuit board. Motherboards are just special names for circuit boards. Some specially designed computers, microcontrollers, or other electronic devices might have special names for their main boards, or they might just have one board.
What would cause breaklights and taillights to keep burning out on a 2002 Chevy venture?
Hi,The tail light socket boards in these vans are well known for having problems.If you have a water leak that is getting into the tail light assembly, that will often cause a short circuit across the "circuit board" and socket assembly that is inside the tail light assembly.What I would recommend it taking the assembly apart and CAREFULLY examining the board and the sockets. Sometimes you will find that there is a partly melted socket, or some other burned component on the board. If you find that condition, you can either try to repair it (if you are good with that kind of thing) or just replace it. You will find many of these circuit board assemblies for sale at auto parts stores, or on line at places like eBay. You might want to consider replacing both boards are the same time if both sides are burning out.Take Care, Greg
Your dash lights don't work on your 2002 Hyundai accent do you know what the problem might be?
I had the same problem. What is happening is that the main circuit board for the instrument cluster is defective. The only way to fix the problem is to have the entire circuit board replaced.
Where would you find a circuit board for a mm defender?
Daves ace website has parts for mosquito magnets-you might try there
Why is your remote not working after you have cahnaged the battery on a jetta 4?
There might be something wrong with the circuit board or something that connects the bateries x
What purpose might the multimeter serve in maintaining and troobleshooting a computer network?
With the multimeter you can measure the voltage on parts of the circuit board. You can also measure the resistance of resistors and make sure there are no short circuits in the circuit.
Why won't 1999 Pontiac Montana tailights work?
ther might be a replacable circuit board of some kind behind the tail light housing
Do hybrid ICs have more than one layer?
They might have more than one layer of traces in the ceramic printed circuit board, but they don't have to.
What kind of information is provided on the website Kentucky Board of Nurses?
The name Kentucky Board of Nurses pretty much tells you what kind of information is provided on it's website. It shows different types of license's there are , it might show who is on the board, and how to get make a report if needed.
What useful information you get by short circuit test on transformers?
You might do a short circuit test to make sure you don't have a direct connection between two nodes that need some resistance between them.
1987 corvette and one half of the dash board doesn't light the half with the tachometer is out?
I don't know how old your question is, but you could have bad bulbs or the circuit board might be damaged. If you are handy you can repair it yourself or sent it to technicar in Fla and they will repair it. I can help if you need it
