The transmission is electronically controlled, get it checked out. I know that the last time I had my transmission flushed by the dealer I noticed an improvement in the smoothness of the shifts , which surprised me because I had the same thing done before, and I had put on just over 18,000 miles since.
where does a shift module go in at on a 1995 ford explorer xlt 4.0 2wd
The shift solenoid on a 2002 explorer transfer case is located on the drivers side.
one of the cables need adjusted or there is a switch on top of the brake pedal that needs adjusted.
Replace shift linkage Replace shift linkage
On the of the shift arm. On the end of the shift arm.
Switch, circuit, shift motor
Shift cable needs to be adjusted.
You may have to have your clutch adjusted,
Low fluid level.Shift cable miss adjusted.Engine performance issue.Internal trans seal failure.Low fluid level.Shift cable miss adjusted.Engine performance issue.Internal trans seal failure.
on the bottom of the transmission
Make sure your car is on.
Shift linkage may need to be adjusted?
Creates a new line in textarea..
my 2001 ford windstar wont shift out of first gear.
my 2002 explorer 4x4 will not shift to 4 high or 4 low
Mounted on the steering column.
it is on the transfer case
bring it to a mechanic...
Shift solenoid malfunction.
ask them about stuff that is crasa
Low on fluid. Linkage mis adjusted or broken. Internal parts malfunctioning.
Sounds like clutch may need adjusted. Or maybe replaced.
Have you ever had the linkage adjusted? 90% chance this is the problem.