0
Where can you buy a transfer case shifter sheet for 1987 Samurai?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Do you have to pull the transfer case to replace the gear shifter seat in a 1987 suzuki samurai?
No, the transfer case 'Shifter Sheet' (not seat) is changed by removing the shifter from the inside of the vehicle. I recommend you get a manual and learn how to remove the shifter. Several are available for free download. It has been a while but from memory I can say that the rubber boot inside is pulled up followed bu the shifter rubber dust boot underneath, then you can push down on the retainer that is around the shifter and give it a 1/4 twist CCW to get it off, the shifter should pop out by pulling up on it. As I recall the knob has to be removed to replace the 'Sheet'.
How do you change the transmission shifter sheet for a 1987 suzuki samurai?
Tha transfer case has a shift sheet, not the transmission. The transmission has a bushing and shift bolt. The bushing is usually rotted and the bolt mos likely sheared in half. When you pull out the shift level, be careful not to let the broken bolt tip fall into the tranny.
What could cause a 1987 Suzuki Samurai transfer case to lock in neutral when shifting from 4h to 2h?
This happened to us recently while we we replacing a worn u-joint. Still do not know the answer but will let you know if we get an answer. Were you able to get it out of neutral and how? Your shifter sheet(bushing)is worn out. Mine just recently had this problem. It is an easy fix but a messy one. You have to remove the shifter from the T-case and clean out the old shifter sheet. You most likely will have to reallign the shift forks inside the t-case. Do this with a long flat blade screwdriver. When the forks are in line the shifter will fall back into place. Press the new shifter sheet into place and replace other parts. The new sheet will have exact instructions with it. It will cost you about $10 for the rubber one or $20 for the poly one. I recommend the poly sheet as it will last the lifetime of the truck. While you are at it you might as well do the transmission shifter sheet too. my name is Danny. i have a 89 zuk. Sammy. my t-case had same prob. so i put a sheet back in. it worked fine then i found a poly. sheet for it when i had same prob with my tranny. when i took rubber sheet out it was already worn in places just after a few months now i have a poly. bushin in tranny and t-case and both shif better then ever has and seems to be Holden u alot longer then rubber. that's a tip to help u save time and a chance of gettn stuck on trail
Does a 1987 Chevy half ton 4x4 have a shifter for 4wd or a pushbutton?
shifter
What is the length of a 1987 Suzuki samurai?
135"
What are the release dates for Spiral Zone - 1987 The Way of the Samurai 1-25?
Spiral Zone - 1987 The Way of the Samurai 1-25 was released on: USA: 23 October 1987
Does 1987 samurai have a manual choke?
No, it has an automatic choke.
What is the spark plug gap for a 1987 Suzuki Samurai?
1987 Suzuki Truck Samurai 1.3L 2BL SOHC 4cylThe Spark Plug Gap.032 (In thousandths of an inch)
Where can you find a 1987 Suzuki Samurai complete engine?
boneyard
Where is bonnet release for 1987 Suzuki Samurai?
In the glove compartment.
How many rpms does a 1987 suzuki samurai have?
try a tach
Shifter knob removal 87 Pontiac trans am?
The 1987 Pontiac Trans Am shifter knob is held in place with a retaining clip below the shifter knob. Push the retaining clip together and the shifter knob will raise off.
