Chevy Monte Carlo
Turn Signals and Hazard Lights
Chevy Camaro RS

Where can you find a diagram to replace a turn signal switch on a 1998 Monte Carlo?

252627

Top Answer
User Avatar
Wiki User
2006-05-24 05:20:58
2006-05-24 05:20:58

Check on this web site: http://tss.likeabigdog.com/ Very detailed pictures and instructions.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 2001 Monte Carlo emergency flasher relay switch and the turn signal flasher relay switch are the same. The flasher relay switch simply plugs in and out.

User Avatar

You probably need a new turn signal switch. I have a '96 Monte Carlo and I had to replace the turn signal switch to get the brake lights to work. Thankfully I had a brother who knew how to take off the steering column and replace. Hopes this helps!!!

User Avatar

When changing anything on a car, a person needs a diagram. A person can get an ignition switch diagram for this car, by buying the cars maintenance manual.

User Avatar

Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.

User Avatar

you will have to replace the complete ignition switch with a new one.

User Avatar

Check out this web site: http://tss.likeabigdog.com/

User Avatar

I had this problem with my Monte Carlo, I think it was that I needed a new turn signal switch. I think there was a sensor or something that was broke too?? But I believe the dash panel lights not working at night had something to do with a short in the turn signal switch.

User Avatar

The turn signal/hazard flasher is integrated into the flasher switch. A very common failure on these cars.

User Avatar

i have a 96 Monte Carlo and i had the same problem. try pulling the turn signal switch to you slightly while in the signal position. works for me every time.

User Avatar

Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.

User Avatar

the brakes are wired into the turn signal assembly. i had the same problem with my car the middle rear light would light up but not the left or right. if you wedge something in the turn signal you will notice your lights work. there actually was a recall on that part.the switch is actually on the brakes that's what makes them light up when you press it. if the wedge doesn't work then you will have to replace the whole turn signal switch located in steering collum. hope this helps

User Avatar

Check for a blown fuse. If the fuse if OK, replace the Flasher Relay.

User Avatar

Its pretty easy, as long as you have or have found a new switch. You just have to go to your local Chevy Dealer

User Avatar

my 95 montey Carlo is doing the same thing, and it is the turn signal switch assembaly,

User Avatar

Possibly a defective Flasher Relay. Replace it. Can also be a turn signal switch going bad. You can try cleaning it with a spray electronic cleaner.

User Avatar

You will have to replace the switch that is under the top cover on the steering column, the steering wheel has to come off to get the cover off.

User Avatar

There is no such car as a 1989 Monte Carlo

User Avatar

where is the oil pressure switch located on a 2004 monte carlo

User Avatar

* It could be a blown fuse or * the brake light switch on top of the brake pedal under the dash is bad or * the turn signal switch is bad.

User Avatar

A 2003 Monte Carlo fan assembly diagram can be obtained from most Chevrolet dealerships. The diagram can be found at most auto-parts stores.

User Avatar

Ask how to replace key switch 2002 Monte Carlo and when you get to remove dash with wire harness in middle stop and you will see three screws holding radio.

User Avatar

A vacuum hose diagram, for your 1987 Monte Carlo, can be obtained from most Chevrolet dealerships. The vacuum diagram can also be found at many auto-parts stores.

User Avatar

Problem most likely is in the Turn Signal switch. I had same problem , replaced Turn Signal switch assembly and that fixed it.

User Avatar

Check bulb (double filamented smaller for turn signal larger for parking/tailight) Check socket for corrosion Replace turn signal flasher or check ur hazard light button i had the same problem


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.