answersLogoWhite

0


Best Answer

This site in the URL below has a description of the fix for the XJ Cherokee, but I would think that the differences between it and the wrangler might not be too drastic. http://www.4x4xplor.com/xj-seat-tilt.html.

User Avatar

Wiki User

โˆ™ 2007-07-09 01:23:47
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where can you find a diagram to replace the cable attached to the loop to pull the passenger seat up for rear seat access on a 1997 Jeep Wrangler?
Write your answer...
Submit
Related questions

How do you replace heater core in 1992 Jeep Wrangler?

free diagram step by step at www.jeep4x4center.com


How do you replace the passenger side door handle on a full door to a 1992 Jeep Wrangler?

I have a 91 Wrangler with full doors. First close the window on the door. Now remove the inside door vinyl panel. The handle is attached from the inside, as you can see. Removal and replacement is obvious from this point.


How do I replace the blower motor on a 2000 Jeep Wrangler?

it is accessable from the passenger side just under the dash. remove the glove box to help.


Diagram for replacing deck belt for a john deere 345?

See the attached link, it should help you replace the belt


How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?

How do you replace the clutch slave cylinder on a 1989 jeep wrangler


Can you replace the distributor of a 89 Jeep Wrangler for a 91 Jeep Wrangler?

yes


How do you replace the fog light switch on a 2000 wrangler?

replace it


How to replace heater blower motor on a 2001 Jeep Wrangler?

right up under the passenger dash there is a black plastic case take of the case the motar is in there un plug it then unscrew the 4 bolts and replace


How do you replace passenger mirror?

Most mirrors are attached with screws on the outside of the door. Otherwise you have to take the door panel off to get to the nuts.


How can you replace the serpentine belt on a 97 grand prix?

....2 ways to replace the best. There is a pictogram on the engine cover; passenger side. On the box containing the new belt there will a diagram for your vehicle.


Where is the Jeep Wrangler slave cylinder?

how to replace the slave cylinder on a 1993 jeep wrangler


How do you replace a mirror on an 04 alero?

The side mirror on my 2004 alero was knocked off. Its the passenger side mirror. How do you remove the mirror because the power cord attached to the mirror is still attached.


How do you replace the inside rearview mirror on a Jeep Wrangler Sahara?

To replace just the mirror, loosen the screw (hex or phillips) and slide the mounting bracket up and off the part attached to the windshield. Slide the replacement mirror on and tighten.


How do you replace a windshield on a 1995 Jeep Wrangler?

you jet some glass that fits a 1995 jeep wrangler


How do you replace the universal in a 93 Jeep Wrangler?

Which one?


How do you replace the water pump on a 2002 Jeep Wrangler?

== ==


Jeep wrangler door glass replacement instrurtiond?

how do you replace a blade wiper motor on a jeep wrangler 2006


What does it cost to replace a 2005 jeep wrangler transmission?

To edit original question....Jeep Wrangler 2005 manual transmission


How do you repair a cloged Catalytic Converter on a Jeep Wrangler?

You will have to replace it.


Cost to replace a Jeep Wrangler transfer case?

about $1000


How do you Replace front seal 94 Lexus and a diagram?

How do you Replace the timing bealt of lexus es 300 92 and a diagram?


How do you replace the starter on a 1989 Jeep Wrangler?

Disconnect battery. Starter is on the lower passenger side of motor. Two bolts hold it on... remove them, disconnect electrical harness. Install new starter in reverse order.


How much does it cost to replace an alternator in a 2006 jeep wrangler?

A lot.


How do you replace 03 Maxima's PCV Valve?

purchase the pcv valve from dealer and get free diagram of its location along with purchase. Usually, you disconnect the whose attached to the valve and pull the valve out.


How long should it take to replace your 2000 Escalade serpentine belt?

Only about 10 minutes providing you still have the routing diagram attached to the engine compartment and a tool for the tensioner on hand.