The 1991 Chevrolet Cavalier transmission linkage can be tighten by turning the adjustment nuts. You will find the adjustment nut on each end of the linkage.
The contact phone number for Cable Dahmer Chevrolet is (545) 431-7758 or one can also find other numbers that are in accordance or near to one's location at the Chevrolet website.
You can remove the parking brake lever, from the brake shoe on your Chevrolet Cavalier, by removing the retaining clip. The retaining clip connects the brake lever cable to the brake shoe.
The shift cable on an 01 Chevy Cavalier is replaced by removing the retaining screws, removing the cable from the shifter, and pulling it from the vehicle. A new cable can then be locked into place and bolted down.
There is no cable, the speedo is run electronically.
The 1999 Chevrolet Malibu automatic transmission shift cable has adjustment nuts on each end of the cable. Turning the adjustment nuts will lengthen or shorten the shifting cable.
there is no cable. it has an electronic transmission with wires
how do you change clutch cable on cobalt
Try soldering it on with a soldering gun
If the heat selector will not switch from defrost to the dash or foot vents on a 1992 Buick, it is possible that the cable connected to the vent is broken. When the selector is moved from defrost, a cable opens the other selected vents on the heater.
Follow the pos battery cable.
It is the black cable on the battery. All GM ground wires are black.
Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
There is no speedometer cable anymore, it's all electronic.
It has a speed sensor on the transmission.
The 1997 Chevrolet Lumina shifter cable is held in place with a swivel nut on each end of the cable. Loosen the swivel nuts and the cable will come off.
Unhook the cable from the Cavaliers battery. Find the opposite end of the cable and pull it out. Fit the new cable in following the old cables route. Connect the non battery end of the cable, then hook to the battery.
At the "Y" in the cables at the rear of the car
If it has a cable attached to the throtle linkage, release it by moving the locking tang and pulling the cable all the way to the rear. Then get inside and floor the accelerator and it will automatically adjust the cable.
There is not an odometer cable. The odometer is driven by the speedometer. If the odometer is not working then you will have to replace the speedometer head.
First, disconnect the negative battery cable, and the instrument panel. Drain the cooling system before you raise the vehicle and disconnect the heater core. Remember to dispose of the drained fluid and return every component to its right place.
remove the positive battery cable for about 20 min.
The 1985 Chevrolet Corvette accelerator cable is held in place with a swivel nut on each end of the cable. Turn the swivel nuts to the left to remove the cable. Reverse the process to install the new accelerator cable.
You didn't mention what year the S10 is but, yours probably doesn't have a cable driven speedometer. It is electronic.