sounds like you installed after market spoiler? then wired to a continuous hot source instead of splicing into brake line witch would be intermittently only when pressing on peddle!
more information needed is it in the window or the design in the spoiler
The center brake light replacement will require replacing the entire brake light assembly. Remove the wiring harness. Remove the center brake light retaining screws. Reverse the process to install the new center brake light.
More than likely a small spring broke in the e-brake pedal assembly. The assembly is not designed to be taken apart and fixed. You will need to replace the assembly with a new one from the dealer or a used one from a wrecking yard.
yes the is a single assembly. replacement assembly is available here http://www.doctorautoparts.com
They're LEDs. If some aren't working the entire assembly needs to be replaced.
If the spoiler is factory installed with a LED 3rd brake light, it will be a dealer item only. You might find a used one in a junk yard, but good luck.
unscrew the light from the spoiler Disconnect the water hose Viola
Remove the tire and wheel. Remove the brake pad Springs. The brake pads and break assembly will come off. Reverse the process to install the new brake pads.
Because you have a spoiler, Honda likely decided to not even include a light socket for the high mount brake light (behind rear window). It's because the spoiler fin blocks this high mount light anyways.Pop the trunk and check to see if a light bulb socket even exists for the high mount brake assembly. If a socket doesn't exist (and you don't see one hanging) then no worries, it was a Honda decision. This is the case for my 2000 Accord EX.
you are thinking of air brake or spoiler
front brake assembly diagram for a 2006 F150 4X4
If you have a spoiler, its in the middle of the spoiler on the trunk lid. Otherwise it should be in the middle of the back window. If you dont have a spoiler, but have a filler panel between the rear speakers at the rear window glass, I suspect someone has removed the spoiler or replaced the original trunk lid with one without a spoiler.
You can get and exploded view of the 1987 Chevrolet rear brake assembly and most Chevrolet dealerships. Most local libraries will have service manuals with the exploded rear brake assembly view.
Brake replacement is provided by nearly all auto repair and maintenance shop and even dealerships provide brake services for your vehicle sometimes under warranty.
On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.
Seal in brake caliper is leaking and needs replacement Flexible brake line to the caliper is leaking and needs replacement
If you are wondering what exactly is the average cost of a brake pad replacement because your previous brake pad is no good anymore, then the answer is around 200-400 dollars.
i need picture of 94 cutlass ceira rear brake assembly
Most auto-parts stores that sell brake drum assemblies will also provide you with an assembly picture. The brake drum assembly pictures can also be found at most local libraries.
I am working on it right now. Any suggestions? Even though the two bolts and two pinch bolts have been removed, it is still tight. What next?
On the brake pedal assembly.
At the top of the brake pedal assembly
If you are wondering how much brake rotor replacement is going to cost because your car needs a new brake rotor, then the answer is around 200-400 dollars.