Check for a vacuum leak.
where is the ecm on a 2000 buick lesabre
You can get a wiring diagram for a 2000 Buick LeSabre at any auto parts store. A Buick dealership may also be able to give you a wiring diagram for free.
i need wiring diagram for 92 buick lesabre
where is the engine controle module located in a 1995 buick lesabre
You can find the heater wiring diagram for a 1989 Buick LeSabre in the vehicle's owner's manual. You can also obtain it from various auto part stores.
Locate transmission modulator 95 Buick
The 1998 Buick LeSabre solenoid can be found on the firewall in the engine compartment. There will be three solenoids on the firewall.
Under hood diagram or autozone.com
The 3.8 litre V6 engine in a 1992 Buick LeSabre has a timing CHAIN
Connect the wiring harness to the back of your 1995 Buick LeSabre stereo. Secure the stereo with the stereo retaining screws.
First you need to troubleshoot the 1994 LeSabre cruise control. Check the fuse, the cruise switch, the linkage, to find where the problem is. Check the vacuum lines on the engine as a vacuum leak can cause the cruise to not work properly.
A fuse diagram for a 1992 Buick LeSabre is available from several auto part store chains. These stores have access to online automotive databases that store troubleshooting and repair information for most vehicles.
The fuse panel diagram for a 2001 Buck LeSabre is located in the service manual. It outlines the location of each fuse and the components it attaches to.
If you look under the dash by the brake petal there is a fuse box and a diagram is on the cover of it.
A free vacuum diagram for a 1996 Buick Regal can be found in its manual. It can also be obtained at an auto part store, as a print off.
Engine will run lean. It will idle rough, have less power, & use more fuel.
Because its a 1988 Buick LeSabre
The starter on a 1989 Buick LeSabre can be found on the driver's side of the engine. It is down low, back by the bell housing for the transmission.
The vacuum supply line from the engine is disconnected or broken. When the vacuum supply is cut off the system defaults to the defrost mode.
autozone.com has alot of helpful info