have a pontiac 6000 2.5 motor and it wont stay running
On the distributor.
2.5L 4cyl base. Iron Duke
Firing order 1-2-3-4-5-6
with air or with out? There should be a white label on your core support or hood underside to show you with air
Could be a bad coolant temperature sensor, fan relay or thermostat. keep in mind the fan motor itself may be bad.
The oil filter on a 1990 Pontiac 6000 is located on the driver's side of the engine compartment. It is on the side of the motor all the way to the rear, near the firewall.
You could call your local auto parts store and they should know the answer to that one
To The Owner of the 1986 Pontiac 6000: I am the owner of two 1985 6000 STE's and my fuel filter is an inline filter on the right side of the car. It is about the size of a soda can. First, shut of power so when you remove the fuel filter, very little fuel will come spurting out. Next, after removing the old filter, plug in a new filter, then restore power. Most Sincerely, Kristopher Gerbracht firstname.lastname@example.org
There appears to be a large amount of information available for the Pontiac 6000 car. If one is wanting to view reviews these can be found on the Edmunds site as well as on Car Guru.
Should be at the bottom or rear of radiator
The weight of the Pontiac 6000 SE is recorded as being 3,021 pounds. This weight can be altered by aftermarket products which are installed on the vehicle or parts which may have been taken off of the vehicle since being manufactured.
The Pontiac 6000 low side air-conditioner import can be found on top of the air conditioning compressor. The low side air-conditioner port will be labeled as the low pressure port.
its called a burnout
It is next to the oil filter.
A sticking choke or vacuum leak are two common causes.
To The Owne of the 1986 6000 SE: The firing order is 1,2,3,4,5,6. Most Sincerely, Kristopher Gerbracht email@example.com
The replacement of outer tie rod ends onto a Pontiac 6000 does not require "measurements." However, the vehicle will need to an alignment after install. An alignment usually takes initial measurements of the wheel geometries, and the technician uses these to adjust the wheels back into specification. For the 1991 Pontiac 6000, the final year of production, the AC Delco Professional outer tie rod is part number 45A0230.
http://www.carsurvey.org/images/pontiac_6000_1.jpg If you mean Pontiac 6000, not 600, which is an old Dodge model, then this is a picture of one.
Yes, but only when you learn to write a coherent question.
In a 2.5L the handle end faces up.
to the Owner of the 1986 STE: I own two 1985's STE's and I noticec the PCV valve is on the front valve cover. I hope this will be of some help. Most Sincerely, Kristopher Gerbracht firstname.lastname@example.org