Best Answer

all you need is an 8 millimeter wrench for the battery cables and a 13 millimeter socket, extension and a ratchet to remove the battery hold down. the battery hold down is at the bottom ofthe battery, and is shaped like a wedge .has a bolt through the middle of it.

User Avatar

Wiki User

โˆ™ 2007-11-30 12:46:32
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Where can you find detailed information on how to remove and install the battery on a 1997 Chevy Cavalier?
Write your answer...

Related Questions

How do you install an alternator on a 1990 Chevy Cavalier?

carefully with tools and the battery disconnected

Install timing chain cavalier 2.2 dohc?


How do you install a 1 gb memory on your laptop?

Please refer to the link below the ads for detailed information.

How do you replace a starter on 2003 Chevy Cavalier?

Disconnect the positive cable from your 2003 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

Do you have to disconnect battery to install stereo on 2004 cavalier or can you remove a fuse?

It would be best to disconnect the battery but removing the fuse will also work as long as you are careful not to disrupt other hot wires while working in the dash.

How can you install a dual battery system?

1) find suitable location for 2nd battery 2) install battery cables + to+ and - to-.

How do you install a starter for 2002 Chevy cavalier 2.2 engine?

Where is the stater located on a Chevy Cavalier located?

How do you install the back seat of a Chevy Cavalier?

NEED help is there a diagram with the bolts in the backseat of a 1998 chevy cavalier?

How do you install a battery in a polaris scrambler 50cc?

im new in ATV a need to install a battery in a polaris scrambler , i have no idea in how to install, help!!!!

How do you install a starter on a 1997 cavalier 2.2 engine?

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

What tool you need to install brake shoes for cavalier 2003?

what tools i need to change the brake shoes for a cavalier 2003

How do you install a starter on a 1998 Chevy cavalier Z 24?

un hook the negitve on the battery. then unhook all the wires from the back of the starter solenoid. then put the two bolts that hod the starter to the block, should be out after that.

how much is the cost to install phone service on my pc ?

Yes there are many grants to assist individuals with going back to school. For detailed information you can visit

How do you install a weapon r cold air box on a 99 Cavalier?

you can't

How do you install the air conditioning parts to the compressor on a 1997 Chevy Cavalier?

what parts

How do you exchange the battery pack on the notebook?

Release a latch and then remove the battery, then install charged battery into laptop.

How do you install a Serpentine belt for a 1996 Chevy Cavalier?

The drivebelt routing decal on the radiator shroud to help during drivebelt install

How do you install a computer into a 1991 Chevy cavalier rs?

Unhook the battery. Remove the glove box door. You'll see the ECM. Unplug the wires to it. There are four nuts that hold it in. Loosen them and take out the ECM. Reverse the procedure to install. Remember to put your original PROM chip in the new ECM.

Why do your battery light comes on after you install a new battery?

Defective alternator or bad wiring.

How do you install car speakers for a cavalier?

Take the door panel off. Match the Wires.

You want to install remote start on a 1995 cavalier anyone have a wiring diagram for that?

How do you install a fuel pump for Chevy cavalier 2000?

Remove fuel tank for access

How do you install a new flywheel on 1998 Chevy cavalier?

Separate the tranny and engine...It's in there.

How to install a battery in a 2000 Chevy Malibu.?

remove negative and positive cables,take battery holddown bolt off,remove battery! when installing new battery, battery hold down first then install the cables , neg first!dont forget to reset radio.

How do you install battery in 2005 harley road king?

Remove the seat. Remove the battery. Replace the battery. Replace the seat.