the cam angle sensor is the crank angle sensor it preforms both jobs
there isn't one
The crank angle sensor is located in the distributor.only in the 94 and 95 Honda accord.
LOCATION OF CRANK ANGLE SENSOR ON 2003 4.7 PETROL MOTOR
You adjust the timing by moving the crank angle sensor. The crank angle sensor is driven by the camshaft closest to the intake manifold (passenger side of the engine) and is located behind the cylinder head and valve cover. Losen the bolt that secures the crank angle sensor, in order to move the crank angle sensor.
in the distributor
in the dist.
heyo captin jack
there is no crank sensor on a Mitsubishi 3000 gt but there is a crank angle sensor that looks just like a distributor its in the back of the engine on top between valve covers
around the optical lens
Crank angle sensor reads rpm and sends the signal to the ECU (computer) to aid in the calculation of engine rpm, ignition timing, fuel injection and crankshaft position.
The crank sensor on the 2.0 DOHC engine is behind the flywheel (flex plate) on the back of the motor. In order to change it you must pull the transmission or motor.
Crank angle sensor
faulty crank angle sensor in most cases
it is in the disturber under the cap
It is integrated in the distributor.
when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.
1991 to 1993 3000gt do not have a crank sensor. Only a cam sensor. And when does go out the car will not start or have a very irregular idle.
where is the crankshaft angle sensor located on a 1997 cadillac deville.
on back of engine behind the flex plate.
i have a 2001 Chevy tracker and i just replaced the crank sensor. i have been having a problem with mine not cranking. i would drive it and cut it off. it would not crank up until after it sat for a while. the crank sensor has not fixed the problem though. you have to take the tranmission out and take the flywheel off. the sensor is behind it. hopes this helps. i got a sensor at napa for about $100. advance auto parts wanted about $174 for it i think
On a 94 Turbo DSM there is no crank angle sensor. The Cam Angle Sensor(CAS)serves the function of both a crank and cam sensor, and it's located on the passenger side of the valve cover at the end of the intake camshaft, you can't miss it.
Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.
You need to remove the serpentine belt and alternator in order to get the crank sensor; one 10mm bolt holds it. It is easy to replace.
Refer to your manual. Buy a Chiltons.