Try looking here for general removal/replacement info... http://autorepair.about.com/library/a/1i/bl830i.htm
need instructions on replacing window regulator
If it is electric windows it is the motor which needs replacing or it could be the regulator
usually by replacing window regulator.
Need instructions on how to replace a manual window regulator on drivers side on 1995 saturn
To remove the drivers side window and regulator, you will need to remove the door panel from the door. Then you can unbolt the regulator and window to remove them.
You have to disconnect the glass from the regulator or clip the regulator cables.See this post for instructionshttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator
The bracket snaps on the window over the plastic pin in the window. You need to pull the bracket away from the window to get it down and over the plastic pin. If you will be replacing the window regulator you can just cut the bracket where it snaps over the pin.
Begin by removing the inside door panel. Remove the wiring harness from the electric window regulator. Remove the window regulator retaining screws.
It can be a broken wire in the hinge area, a bad switch, or simply a bad window regulator.See this post for instructions on how to diagnose the problem:
The window is not off track. The window regulator is broken. In most cases you will have to replace the window motor and regulator as an assembly.
The motor and/or window regulator may need fixing or replacing. See "Related Questions" below for more
replace window regulator
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
replace window regulator assembly.
Apparently after 36 years the window regulator needs some lubrication ! I removed the window and then the regulator and then lubed the whole of the regulator using a silicone spray. Fixed ! Getting the regulator and window back in the door was a whole other story.
The process to replacing the window regulator involves removing the door panel,connections to the window switch and also the door handle bezels. I've included a video that will show you exactly what tools you need and how to get at the window regulator so that it can be replaced.
When replacing the regulator on a 2006 Ford Fusion, you need to follow the instruction on the manual so as to be able to replace the actuator on a 2006 Ford Focus with power window.
turn bolts to the left, install regulator, turn bolts to the right
Complete instructions with photos:
Replace the window regulator.
I AM GOING THROUGH THIS MYSELF. i HAVE LOCATED THE PART ON WWW.ROCKAUTO.COM (DORMAN PART # 74168) FOR 77.70 FOR THE MOTOR AND REGULATOR. i WILL POST MORE ONCE i REPLACE IT.
Window motor and regulator are found inside of the door panel and may be bolted or riveted in. Should be bolted. Disconnect the window from regulator, take out reg. and motor, then disconnect regulator from motor, reconnect new motor to regulator, reattach those inside of the door, then reconnect the window to the regulator, put it together and see if it works.
Chilton repair manuals for the Ford Fusion 2006 will show someone with mechanical experience how to repair the regulator. It would be best to take the vehicle to a mechanic if the owner does not have mechanical experience. This will insure that the regulator is repaired properly.
Check the clip fron the window to the regulator. These will break off and you will hear the motor working but the window will not go up or down. You can replace your regulator and motor as one unit for little cost, if broken. You might get away with just replacing the clip to your window/regulator.
See this post for instructions and photoshttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator