The Dodge Intrepid has front and rear brake hoses
No, doing a brake job does nothing to the front end.
Replacing Brake PadsThis will depend on the vehicle. Try asking a more specific question. brake pds 2006 1500
It sounds like you have air in your brake lines. It sounds like you have air in your brake lines.
Yes , the 2002 Dodge Intrepid is front wheel drive
Remove caliper, pull rotor off hub, push new one on.
Visual instructions for replacing the front bumper on your Chevrolet Lumina can be found in most service manuals. The instructions can also be obtained from most auto-parts stores.
If you are talking about the brake sensors then it is time to replace the front brake pads. You should also check the rears while you are at it. When replacing the front brake pads you will also need to change the sensors also.
Sounds like air in the brake lines or power steering fluid in the brake system instead of brake fluid.
The minimum front brake rotor thickness is three aids of an inch. When the rotor does not have the minimum thickness the auto mechanic replacing the brakes can not use the rotor.
I place them under the suspension cradle (the large metal framework).
These instructions are for the front brakes, but they are similar. http://www.hspn.tv/?videoid=44&catid=1
The Dodge Intrepid was always front wheel drive.
yes it has to be remover but the brake line can stay attached
WELL, I HAVE A 2005 TOYOTA SUV AND I JUST HAD MY FRONT ROTORS AND BRAKE PADS REPLACED AND IT COST ME 325.00. If you do it your self it is about 140.00
try replacing the turn signal/hazard flasher unit - it is a very inexpensive part. Located: Front seating area, driver side, under left hand side of instrument panel between junction block and brake pedal.
When you're brake pads be calm worn, they will have a slight shimmy when you apply the brakes. When the brake pads are completely worn out they will make a grinding noise.
if ur mechanic is anything like mine £130
The most effective brake is the front brake.
Chilton and Haynes each have a manual with step-by-step instructions and illustrations.
on the bottom/right front...if looking from in front of vehicle
you might have a bad speed sensor or a bad front wheel bearing causing the light to go onTRy replacing the sending unit they go bad very often turning rotors and replacing pads is not the way to fix this. it is the abs sending unit and it needs to be replaced.the correct part you will need to replace is called the wheel speed sensor not sending unit