Be the first to answer!
It is the turn signal switch combined with the head lights, wipers, etc.
Plymouth does not use inertia/reset switches
Plymouth does not use inertia switches.
Headlights, interior lights, parking lights,Headlights, interior lights, parking lights,
Check the fuse for the headlights. It is probably open.
The lever you move to activate the turn signals is the multifunction switch.
No, the fog lights have a switch.No, the fog lights have a switch.
Chrysler/Plymouth/Dodge vehicles do not use inertia/reset switches.
on the same switch that turns your head lights on...you should see a little pull switch at the tip, when you turn on the headlights pull it out...it will not work unless the headlights are on
its on the left turn signal switch, at the end is the headlights, then one in is the fog lights, you twist it just like you would the headlights
maybe you should try putting it in a drive. its the D letter on the gear switch =)
you need to get a manual for the car and look in it
Look at the bracket where the brake pedal mounts, you can't miss it.
could be bad wiring
The switch is not a switch. It is a light for the ashtray itself. It will only be on when the car has the headlights or running lights on.
Pull the wiper/turn signal stalk towards the back of the car.
With most vehicles you can turn on the parking lights or the headlights and the dash illumination lights light up without turning on the ignition switch.
if you've tried hitting the high/low beam switch & headlights are out on both, then a bad headlight switch or headlight switch plug or high/low beam switch plug not fully engaged.
Switch? both headlights?
where you turn on the headlights ... push the button
one of two things, BAD EARTH, or Relay switch.
First check your fuses if none are blown then check the switch.
It is the same as the switch to turn on the headlights. Pull it out toward you.
It's part of the headlight switch. With the headlights on, just pull the switch straight out towards you.
You can,t switch between high and low beam in DRL mode. Only when you turn on the headlights with the HL switch.