# Disconnect the negative battery terminal. # Position the lock cylinder in the LOCK position. # Remove the steering column lower cover. # Loosen the two nuts on upper steering column, allowing the column to drop. WARNING
Do not remove the nuts, as the column may bend under its own weight.
# Disconnect the ignition switch connector at the switch. # Remove the two screws securing the ignition switch to the steering column. Remove the switch. To install:
# Assemble the ignition switch on the actuator rod and adjust it to the LOCK position, as follows: ## Standard Column - Hold the switch actuating rod stationary with one hand while moving the switch toward the bottom of the column until the switch reaches the end of its travel (ACC position). Back off one detent, then, with the key also in the LOCK position, tighten the two switch mounting screws to 35 inch lbs. (4 Nm). ## Tilt column - Hold the switch actuating rod stationary with one hand while moving the switch toward the upper end of the column until the switch reaches the end of its travel (ACC position). Back off one detent, then, with the key also in the LOCK position, tighten the two switch mounting screws to 35 inch lbs. (4 Nm). # Connect the wires, tighten the two steering column nuts, install the lower cover and reconnect the battery. If you need a diagram,go to autozone and purchase a Haynes repair manual. or check at your local library for a mitchells or chiltons reference manual
how do you get ignition switch out of steering column in 2000 catera?
diagram colors to conest ignition switch
wiring diagram ignition switch el camino 71
Ignition wiring diagram
You can remove the 1999 Cadillac Deville ignition switch by removing the retaining ring. The retaining ring will be at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the back of the switch. Reverse the process to install the new switch.
Usually by removing the old switch and replacing with a new switch.
When changing anything on a car, a person needs a diagram. A person can get an ignition switch diagram for this car, by buying the cars maintenance manual.
I need a Diagram for a 1995 Chevy Lumina iginition switch??
please give instructions on replacing the ignition switch on my 99 Malibu
pics of 1992 4runner ignition switch
i need a wiring diagram with pictures to help put my ignition switch back together on my 99 olds intrigue
Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?
On the steering column????
Take it to a shop
With care and precision.
wiring diagram of ford ltd 1978
Steps to replacing 1997 Mercedes-Benz C280 ignition switch?
unplug the battery for 2min
Ignition switch doesn't lock up if you lose remote. Your problem is a bad ignition lock set and not the ignition switch it self. There are 2 pieces to the set up, 1 is the lock and 2 is the switch. If your key can go in and turn to the "acessories" or "on" position, then it can de replaced rather easily. If your key can't turn at all or won't go in,(lock set) it can still be changed but it's a little harder to do. You can do this with out replacing the ignition switch.
Remove steering wheel and signal switch
how do you remove the ignition switch on a 1987 firebird
its not your ignition its your crankshaft sensor that's the same problem i had.
Fuse Link @ starter--- Ignition Switch------- Netural Saftey Switch- Bad ignition switch, or bad neutral safety switch.
you must check the brake pedal release switch it will have probably failed at the same time as the ignition switch was replace by coincidence or you bumped the wire off replacing the ignition switch