just right of the exhaust manifold. little black rubber pipe/elbow connects to it.
on the valve cover it will have a small vacum line coming out of it. it looks like a little elbow
Spray starting fluid around the engine. its probably the pcv elbow beside the exhaust manifold or the pcv end assembly elbow on the bottom of the intake manifold. Mine had both elbows almost in half.
I have a 1998 Ford Escort ZX2 and the PCV valve was located to the right of the exhaust heat shield in front of the engine block. All I had to do was pull the rubber elbow out that was connected to the PCV valve and then pull the valve out. It was arguably the easiest maintenance work I've done on a car. I didn't have to take apart the heat shield or any other component.
On the bottom inside next to the engine on the air intake there is a elbow there that can become bad and make a air leak
Attached to the valve cover is a hose on the driver side. Unscrew the nut closest to the valve cover and that is the PCV valve. It is a straight PCV valve, not the elbow shape you may be looking for.
It's on the left side of the valve cover. It's an elbow and the tube goes to the intake
Engeine spec ford zx2 essort 2000
It should just be a 3/16 elbow hose. So yeah, I would say so. Matthew D.
It does not have a pcv valve. The system uses a fixed orifice in the rear elbow on the valve cover.It does not have a pcv valve. The system uses a fixed orifice in the rear elbow on the valve cover.
Just replaced mine. Dealer item only. $21
Just replace it with a new one.