well depending on which one you are refering most can be purchased at an auto parts
If you look under the hood you will see a sticker with all the vacuum lines on it.
235 horse is stock on 98 305
6 degrees before tdc with distributor vacuum line removed and plugged
If it has a 305 around 15mpg If it has a 350 13-14
Yes it will fit right in there with no modifying.
Yes, but the exhaust Y pipe from the 305 may not fit the 350.
Show diagram for Chevy 305 engine
There are all kinds of reasons for this; out of time, needs a tune up, vacuum line(s) not connected, dirty fuel filter. Check all the above.
Yes they will. I have 305 24" wheels for my 01 Tahoe. They fit well.
Your local library has auto repair books that have wire and vacuum diagrams in them. They usually have them behind the counter. So you'll have to ask the staff for them.
A small one with vacuum secondaries.
steering weel collumn, check autozone
1988-1996 350 and 305 engines with (TBI)- throttle body injection.
305(5.0) or 350(5.7) most likely a 350
the gap for the 1983 Chevy c10 silverado is 0.035 ("35 mils") 0.889mm
on the back of the throttle body or intake port.
pick up a chiltons repair manual from the library for your car.
The only vacuum lines you need on the old carb moters is for ur break booster and vacuum advanced distributer
A/C Belt Power steering belt. Alternator belt Air pump belt.
If the Buick 305 is really a Chevy 305, then the motor mounts will interchange with a Chevy 350.
It needs to be attached to a full time vacuum source such as a port on the intake manifold.
To remove the heads on a 305 Chevy, first disconnect the battery, carb and throttle cables. Also disconnect the sensors and vacuum hoses. Unplug water temp gauge sensor on the thermostat and disconnect pump from brackets.
A tan/white wire goes from the sending unit to the fuel gauge typically on a (example) 1985 Chevrolet Silverado 305 tbi.
You could put a vacuum gage on the engine and time it for peak vacuum. A timing light is still better.
If your transmission has a modulator it is on the side of the trans and it has a nipple on it for the vaccum line. I you. Mark