This is located in the engine compartment on the firewall. Located on the passenger side near the top. Once you pull the computer out be sure to have a anti-static mat to place it on! This is super important. Also take the unit out VERY gently when removing or you will cause damage to the unit. Good Luck :-)
in the computer
The servo is under the battery. The engine computer controlls it.
It is part of the computer behind the battery.It is part of the computer behind the battery.
where is the pcm module located on my 1997 Chevy truck
no such switch.
1994 - 2005 Mazda Pickups Repair Manual lists a Power Control Module (PCM) located on the passenger side of the engine compartment, along the upper edge of the firewall.
Yes, the 1983 Ford Pickup has a computer called an EEC or Electronic Engine Control. The EEC is a rectangular shaped box connected to the distributor. Look for a thick wire coming off the side of the distributor and trace it back to the EEC module. Some of them are located by the battery and some are under the dash. It depends on the style of pickup for that year.
It could be the pickup coil, the module, the computer, bad connections... a lot of it depends on the vehicle and the type of electronics. You might need to refer to a service manual that was written for your vehicle.
No, because the transmission control module and speedometer will not line up, so it will not work.
how do you remove the ignition control module on a 1988 ford f-250 pickup?
A Ford Explorer Sport is a 2 door model, while the Explorer Sport Trac is a 4 door model with a small pickup bed.
You need to ask a more complete question.