Car Computers and Sensors
Jeep Grand Cherokee
Jeep Grand Cherokee Laredo
Jeep Grand Cherokee Limited

Where can you locate the coolant sensor on a 1996 Jeep Grand Cherokee Laredo?

141516

Top Answer
User Avatar
Wiki User
Answered
2007-06-28 14:31:48
2007-06-28 14:31:48

On a V8 there are two sensors, the are located on either side of the neck where the thermostat is located. Standing in front of the vehicle the one on the left is for the temp. guage, the one on the right is for the computer. If it is the six cylinder and you're getting the "COOLANT SENSOR BAD" message on the VIC that refers to the level sensor in the header tank. I have this problem and the sensor is not At Fault. From investigations on the web it seems that the connections on the VIC are the problem, possibly dry solder joint. Difficulty is getting the VIC out!

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The engine coolant temperature sensor is the sensor that is screwed into the thermostat housing on the top front of the engine.

There are two separate sensors that play here. the "coolant temperature sensor" and "coolant LEVEL sensor". I suggest confirming which of these was replaced, as it is very common for them to be confused. likely you will find the coolant sensor that was replaced was the one on the engine (temperature); The LEVEL sensor is mounted either in the coolant resivoir or in the radiator. Probably just need the proper sensor replaced.

Check your fuse, and your coolant temp sensor. The coolant temp sensor is more than likely the problem

where is the coolant temperature sensor locate

The coolant temperature sensor on a 2001 Jeep Cherokee is located in the intake manifold. It monitors the flow and temperature of coolant through the engine.

how to locate engine coolant temperature sensor on a 1999 Cadillac De Ville Concurs

It means your coolant sensor is bad and needs replaced.

It is the three wire sensor on the throttle body.

Usually a crankshaft sensor is located on the bellhousing of the transmission

The coolant temperature sensor on a 2001 Jeep Grand Cherokee is located on the T-stat. It is on the passenger side of the Jeep.

The range sensor is the sensor that tells the computer what gear its in. Its called a transmission range sensor

A sensor could be the reason why a 94 Jeep Grand Cherokee Laredo fails to start. The crank position sensor is often the problem. You can try unplugging the sensor for several minutes and then plugging it back in to see if that fixes the problem.

in the valve body which is inside the transmission.

What type of coolant sensor? The below answer is for the coolant LEVEL sensor. The coolant TEMPERATURE sensor on my vehicle is located just next to the thermostat housing. On the front top center area of the engine just behind the radiator. Follow the coolant hoses if you have trouble. On my 1995 Jeep Grand Cherokee the sensor is located on the top of the plastic coolant reservoir tank. Look for a small (2-wire?) electrical connector.

whee is the coolant sensor location in a 1999 Cherokee classic] i believe its located somewhere on the exhaust

It is the two wire sensor next to the thermostat housing.

coolant temperature sensor are located where the coolant runs in the block near the thermostat housing normally the connector are on top of the sensor and the sensor itself screws in with a deep socket. The temperature sensor is usaully located where the coolant runs OUT of the engine close to thermostat housing.

the temp sending unit for the gauge is located on the top of the motor on the driver side next to the valve cover in the back. The engine coolant temp sensor for the computer is in the thermostat housing.

On the coolant overflow bottle that in on the passenger side of the engine.

The crankshaft position sensor is on the top driver side of the transmission bell housing.

Take the transmission pan off>take filter out>govenor sensor housing in this area

There are two separate sensors that play here. the "coolant temperature sensor" and "coolant LEVEL sensor". I suggest confirming which of these was replaced, as it is very common for them to be confused. likely you will find the coolant sensor that was replaced was the one on the engine (temperature); The LEVEL sensor is mounted either in the coolant resivoir or in the radiator. Probably just need the proper sensor replaced.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.