answersLogoWhite

0


Best Answer

Connect a fuel pressure gauge to the schrader valve located on the fuel rail that feeds the fuel injectors.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where do you check fuel pressure on a 1990 suburban with a 454 engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat on a 1990 gmc suburban?

Just follow the top hose, from the radiator, to the engine block. It will be at the end, on the engine block


Average mpg 1990 Chevrolet suburban?

About 15 mpg on a 1990 Chevrolet suburban.


My 1990 Mitsubishi montero runs for a few seconds and then dies..what do i do?

Check the fuel filter and the fuel pump pressure. The problem sounds like the fuel pressure is too low to keep the engine running.


How many mpg 1990 Chevrolet suburban gets?

1990 Chevrolet suburban gets about 15 mpg.


Will the engine from a 1990 Chevy Suburban fit in a 1988 Chevy pickup?

YES, They are the same engines. That would be a direct bolt in.


How much fuel pressure should a 1990 suburban have?

It MUST HAVE 9 to 13 LBS. NO higher are Lower are you will have starting and running problems.


How do you retrieve the check engine light on a 1990 cavalier?

The check engine light cannot be retrieved on a 1990 Cavalier unless a problem develops with the engine. The engine can be checked for errors, though, by using a tester that is plugged into the vehicle's computer.


Why does your check engine light flash on your 1990 pathfinder?

If the check engine light is flashing it indicates that a cylinder misfire has been detected.


Where is the low pressure port on a 1990 ford van?

The low pressure port on a 1990 Ford van is in the rear of the engine compartment. It is on the passenger side, near the firewall.


How do you reset 1990 Toyota Camry check engine light?

how to reset oil timing on 1990 toyota


What would cause the fuel system in your 1990 3.1 cavalier to lose pressure when NOT running?

it has a machanical fuel pump mounted on the engine. so there would be no pressure as you turn the ignition on, but would only get pressure once the engine has turned a few times, by the starter motor, in order to create fuel pressure. but check your fuel lines, usually they would be your problem


What should the fuel pressure be for a 1990 Chevy Celebrity 3100 v6 engine?

The fuel pressure should be 45 psi .