answersLogoWhite

0


Best Answer

inside the hood on the driver side fire wall near the master cylinder

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where do you check the fluid on a 1990 Ford Ranger for the clutch?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

My 1990 ford ranger will not shift into gear?

A 1990 Ford Ranger may not shift into gear if the clutch is out. A clutch can be purchased at any auto parts store.


Clutch went out on 1990 Mazda rx7 It was fine then got hard to shift and clutch lost spring. It has fluid What could it be?

Check for bad clutch master cylinder or slave cylinder.


Where to add clutch fluid 1990 ranger?

there is a small black plastic cap on the driverside underhood i believe it's one the fender over next to the brake master cylinder.


What tranny fluid for a 2.3 1990 ranger with a Mazda tranny?

can you answer the question i have a 1990 ford ranger with a Mazda manual transmission what fluid does it require


How do you check clutch cable on your 1990 Mazda 323?

caint it has a hydraulic clutch


Where do you add clutch fluid in a 1990 300zx?

Right at the clutch master cylinder reservoir under the hood.


How do you fix a 1990 Toyota Camry clutch wont engage?

check the slave cylinder,if its dry add fluid and then press the clutchin and out about 15 times


How do you adjust the clutch on a 1990 Chevrolet 1500?

the clutch system is self adjusting no adjustment can be made . check the clutch master cylinder reservior


How do you Drain transmission fluid on 1990 ford ranger?

Remove the transmission oil pan


Why does the Emergency Brake light stay on even when the brake is off in a 1990 Ford Ranger?

Check your brake fluid level in your brake master cylinder in the engine compartment and see if it is down.


How do i check transmission fluid in a 1990 Chrysler 300?

There wasn't a 1990 Chrysler 300.


What if your 1990 Nissan d21 4 cylinder 5 speed does not go into gear you think you blew the clutch but you heard it has a hydraulic manual transmission is it possible you are low on hydraulic fluid?

u have a slave cylinder bolted on the side of the transmission,check to see if it is leaking,if it is ,replace and bleed,if not leaking .check your clutch master cylinder to see if its low, if not ,then u may need anew clutch.