under the lower intake manifold
That year did not have a cam sensor.
Need to know what engine it has.
That is the knock sensor
it is located on the side of the engine block.
to the rite and just below the coil
iF YOU SLIDE IN UNDER THE TRUCK BEHIND THE PASSENGER FRONT WHEEL AND LOOK UP AT THE BOTTOM SIDE OF THE ENGINE, YOU WILL SEE THE STARTER. NOW JUST IN FRONT OF THE STARTER A FEW INCHES YOU WILL SEE THE KNOCK SENOR SCREEWED INTO THE SIDE OF THE ENGINE BLOCK. iT CAN BE HARD TO SEE.
can i see a diagram of the location of the abs sensor on 1989 F-150?
It is located on the side of the Engine block.
the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off
The knock sensor on a Chevy Celebrity 2.8 L engine from 1987 thru 1990 is located on the back side of the engine(next to the firewall) below the exhaust manifold. There are actually two sensors there, one is the knock sensor, the other is the crankshaft position sensor. The knock sensor is threaded into the block with a pipe thread, the crankshaft position sensor is held in with a 10 mm screw and is near the center of the block. They are both accessible with the engine in the car, but they are a bit of a pain to get to.l
1988 to 2000 GMC & Chevrolet pickup truck parts are, for the most part, interchangeable.
I own a 1990 GMC Sierra 1500 5.7L V8. My fuel filter is located along the frame rail under the cab on the driver's side of the truck. You might look there for the filter on your 1989 Sierra. It's an inline silver colored canister.
Adjust ignition timing. check knock sensor.
behind the engine,in front of the transmission, about half way up the side of the block, its very hard to see its near the knock sensor.
temp switch if its on front if its on back knock sensor
It is screewed into the passenger side of the engine block, JUST IN FRONT OF THE STARTER. You do not need to remove the starter to see it.
The knock Sensor in a 1989-1992 Toyota cressida is located under the intake manifold, closer and under the cold start injecter. Behind the alternater. i had to use a small mirror to see it, or you can put your hand under and search for it. Also look at this tread forum: http://www.toyotanation.com/forum/showthread.php?t=213375 Thanks
Neither the front or rear bumper of a 1989 Chevrolet truck will fit on a 1989 Dodge truck. The bolt patterns are different and will not line up.
back center of the block right above the oil pan it has 2 wires going to the one above it with one wire is the knock sensor
thats your knock sensor ESC is Electronic Spark Control which governs timing.
Fuel pump relay or Knock sensor if stall after maybe 2 miles
Toyota V6 1989 Oxygen senson is located on the driver side in front of the catalytic convertor. It has four wires and held on by 2 bolts.
A 1989 5.9L Cummins does not have a cam sensor.