where is the fuel pump shutoff switch for a 1996 mercury mountaineer
On a 1998 Mercury Mountaineer : According to the Owner Guide : ( the fuel pump shut off switch / inertia switch is in the front passenger footwell behind the kick panel ) * the kick panel is the interior trim panel , just in front of the front door , beside the persons feet
bad switch or possibly stuck switch
In the front passenger footwell , behind the kick panel
No , the 5.0 liter V8 engine in a 1998 Mercury Mountaineer has ( 1 ) timing CHAIN
How do i change the chain out of my 1998 mercury mountaineer transfer case
Yes , according to the 1998 Mercury Mountaineer Owner Guide : ( the headlight bulb is # 9007 )
If you have a 1997 to 1998 Mercury Mountaineer or Ford Explorer with a V8 engine, you will have a 4R70W transmission.
how do you change wheel bearing on 98 mercury mountaineer
The easiest way to reset the antitheft system in your 1998 Mercury is to remove the antitheft system fuse. Keep the fuse out for 10 seconds and then replace it to its original position.
The starter on a 1998 Mercury Mountaineer is located on the passenger side of the engine. It is down low, almost underneath the motor.
no it is fuel injected
on the transmission
If your overhead compass on your 1998 Mercury Mountaineer does not work, the fuse could be what is wrong with it. Check the fuse and replace it as needed.
my 1998 mountaineer hood release will not work. Is there another way to open it?
On a 1998 Mercury Mountaineer : The automatic transmissions are ELECTRONICALLY controlled , so there is no modulator
On a 1998 Mercury Mountaineer : Yes , both the 4.0 liter , SOHC , V6 engine and the 5.0 liter V8 engine are fuel injected
The 1998 Mercury power window relay switch can be found below the dashboard. The relay switch will be on the drivers side of the dashboard.
The low pressure port on a 1998 Mercury mountaineer is located on top of the ac drier. The drier is mounted close to the radiator on the passenger side.
It has a vacuum leak somewhere.
1998 Mercury Mountaineer rear wiper troubleshooting - check in this order: Fuse, switch, spindle/tightness of arm, motor, wiring. See the Sources and Related Links section below for rear wiper blade information.
If you don't see any gas leaking or smell gas , press the button on the top of the inertia switch if it has popped up . Turn your ignition key to the RUN position for a few seconds , turn the key off and recheck for any leaks or gas smell . If none , start your engine