answersLogoWhite

0


Best Answer

The first is to remove the stock Oil sender unit for the warning light on your dash, most cars this sensor is not connected to your PCM and removing it will not affect anything.

You could also install a t-fitting that you can purchase from a local hardware store in order to hook up both factor and aftermarket senders.

Confirm this with your dealership or owner's manual before removing the sensor. If everything is ok then you can install the sender that came with the gauge.

Follow the Link.

Hope This Helps.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where do you hook up a aftermarket oil pressure gauge on a 1989 4.3 s-10 Blazer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is fuel pressure port on 1989 4.3 Chevy blazer?

It doesn't have a test port. You have to fabricate fittings to tap into the fuel line at the fuel filter to connect a fuel pressure gauge. They probably sell a kit to do that but I made my own.


Why are the taillights and gauge lights out on a 1989 Chevy Blazer?

About the only thing they have in common is the headlight switch. Have it checked out.


How do you read the Oil pressure gauge on a 1989 mercury cougar?

with your eyes


What causes low oil pressure in a 1989 4.3L?

weak oil pump, worn crank shaft bearing, or a bad oil pressure gauge all these can be contributing factors. Best place to start is with the pressure gauge.


1989 s10 blazer?

OK, you have a 1989 S-10 Blazer. What is your question?


1989 Chevy Blazer?

What about it?


Where is the oil pressure switch on a 1989 ford aerostar?

On a 1989 Ford Aerostar : I believe the oil pressure sending unit for the oil pressure gauge on the 4.0 liter EFI , V6 engine is on the drivers side of the engine below the power steering pump


Will a 1989 Chevy Blazer transmission fit a 2000 Chevy Blazer?

No it will not even bolt up. GM redesigned the transmission and its not even close to being the same as the 1989 trans.


Is the speedometer on a Chevy Blazer electronic or by cable?

I believe that the first digital cluster on a S-10 Blazer was in 1989.


What other years blazer parts are interchangeable with a 1989 Chevy blazer?

1982 - 1994 (early year models).


Where is the oil pressure switch for a 1989 oldsmoblie cutilass?

The oil pressure sending unit is by the oil filter. There are 2 different types. One for a gauge and one for a light. Make sure you get the right one.


You have no dash lights at all in your 1989 s10 blazer what could be the problem?

If you have no dash lights at all on your 1989 S10 Blazer, a blown bulb can be the problem. You should also check the fuse.