answersLogoWhite

0


Best Answer

Go to auto zone and they will read the codes free. PRBABLY ON TOP OF THE ECM. A 1991 IS LOCATED IN THE RIGHT KICK PANEL BY THE DOOR. IF THERE IS KNEE BOLSTER ON THE GLOVE BOX YOU MAY NEED TO UNSCREW THAT TO GET IT OUT OF THE WAY

User Avatar

Wiki User

โˆ™ 2007-05-23 20:05:47
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where do you hook up a scanner to the ECM on a 1992 Lemans?
Write your answer...
Submit
Related questions

Where do you hook up a scanner to the ECM on a 1994 Dodge Intrepid?

the little six pin blue connecter under the left side of the dash


Will a 1996 firebird ecm work in a 1992 sunbird ecm?

1992 sunbird is obd1,1996 firebird is obd2.Will not work.


Where is the ECM located in a 1992 Chevy S10 blazer?

The ECM on a 1992 S10 Blazer is located below the glove box.


Where do you hook up my scanner to THE ECM IN a 2005 Dodge Magnum?

The OBD2 diagnostic port is under the dash on the driver side.


Obd not communicating with scanner on 2000 olds silhouette?

If you're sure you've got the correct scanner and using it correctly then it is highly probably you have a bad ECM.


You changed the ecm on a 2001 Pontiac grand am and it wont start?

Where did u get your new ECM? You probably need to have it " flashed" @ a gm service dept. Or a shop with tec2 scanner


Does a 1992 camaro z28 with an LT1 have an ecm and pcm?

Is this a Factory LT1? In your 1992 Z28?


Where is the ecm on 1992 Integra?

Under the passenger seat.


Why wont your snap-on scanner read the ecm on a 92 dodge stealth with a no start no spark condition is it an ecm problem or ground problem?

scanners work for 96 vechicles or newer


Where is the ecm located on a 1992 Plymouth duster?

It is behind the battery.


How do you disable the governon on a 1992 mack truck?

Reprogram the ECM.


What signal wire from ecm do you use to hook up a tach 99 eclipse?

you dont use the ecm, you use one of the wires from the second injector, i think its blue


How do i Increase limited speed on Volvo truck?

That's programmed into the ECM. You'd need to hook a computer with the appropriate software for the engine to the ECM, and adjust the settings there. If it's not your truck to do this with, then the ECM will most likely be password protected, and you won't be able to do this.


Flash 1997 Chevrolet truck engine code ecm?

IF YOU JUST WANT TO ERASE THE ENGINE CODE GET AND OBD2 SCANNER THEY HAVE A CODE RESET FUNCTION. IF YOU NEED TO FLASH THE ECM CHECK THE DEALER FIRST, BUT SOME AFTER MARKET AUTO PARTS STORES CAN REFLASH ECM'S


Where is computer hook up on a 82 corvette?

Behind driver seat in with battery , have to take battery out to get ECM out. First check 20 amp fuse next to battery it is for the ECM , protects it.


Where is the ecm on 1992 BMW 525i?

The ecm is under the dash above the glove box. Above and to the left of that ( smaller box ) is the cruise control module.


Where is ECM computer on 1992 Chevy Astro?

behind right kick panel


What is error code F32 on a 1992 Cadillac Sedan Deville?

F32 - basically what it comes down to is shorted wires between the ECM and BCM, a bad ECM or BCM or a faulty prom or memcal inside the ECM or BCM.


How do you test the ecm on a 92 astro van?

The 1992 Chevrolet Astro Van ECM can be tested with a diagnostic tester. Most auto mechanic shops have diagnostic testers.


Where is the ecm located on a 1992 safari?

The ECM is located behind the right side kick panel. If you sit in the passenger seat,the kick panel will be next to your right foot.


How do you adjust the idle control valve on a 1992 caprice classic?

You don't. The ecm adjusts it.


Where is the ecm located in a 1992 Chevy s10 pickup?

Inside the dashboard, to the right of the glove box.


How do I access ECM on 2003 Kia Spectra?

There's an OBD2 port on the LH side of the dash, under the steering wheel... you plug an OBD2 scanner into there.


How do install the ECM in 1992 Geo Tracker?

it is behind the drivers side speaker u have to remove the speaker, und bolts on ecm and lift it out. then you put in the new one a plug it in. no programming is required.


Where is the Location of the component center in a 1992 Lumina?

There is no such thing on Lumina. However if you're talking about the ECM (electronic control module), then you'll need to remove the coolant reservoir. The ECM is located under it.