where do you install a new flasher for a 1991 Acura Legend?"
Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
an acura is an American car and get a new car
my Acura legend brakes are fine and Thank you the problem is my interior inside my car looks like dirty and i need to clean it so it will look brand new... I love my 1992 Acura Legend.
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
Remove the flasher retaining bolts from the headlight assembly bracket. Remove the wiring harness. Reverse the process to install the new flasher.
You can find the heater core behind the kick plate in your 1993 Acura Legend. Remove the water hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
The 2010 Acura Legend does come with GPS. Through the GPS system you can control the climate of your car as well as get maintenance updates.
To change a 1995 Acura Legend starter, remove the 4 bolts around the intake pipe and lower radiator hose. Remove the starter and replace with new.
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
Open driver side door, there will be a fuse box located in the dash. locate flasher (it will be labled) remove it and install new on.
unplug old one install new one
You remove the clips on the top, screws by the fenders, remove foglights if equiped and remove the bumper, install the new one in the opposite order.
Bearings require a mechanical press to be properly changed in an Acura Integra. Remove the hub from the vehicle and take it to a press. The machine will properly install a new bearing and ensure a safe install.
The oil pan on a 1995 Acura Legend is changed by draining the oil, removing the retaining bolts, and lowering it from the engine. The components are then cleans, a new gasket installed, and the pan bolted back in place.
The new hood will fit as long as its between 91-95 and if you have a coupe the hood needs to be from another coupe, the sedan hood will not fit on the coupe or vice/versa. Hope this helps!
Buy a new one, remove the old one and install the new one.
To replace the clutch disc in a 1991 Acura Legend you must first remove the engine from the vehicle. Loosen the pressure plate by adjusting the bolts and remove. Put the new one where the old one was and tighten the bolts.
My legend had that when i first got it its a bad headlight switch i suggest going to the junkyard and pull a new one costs arounf $35 and install it problem solved i.e. bad terminal in switch
To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.
Did you install the correct bulbs? Replace the flasher unit ------------------------------------------------------------------------------------- Yes! Flasher unit. Y-THINK-Y
Save up your money and have the job done by a pro, honestly, its a pain and not worth the savings.
I found the flasher under the dash on the drivers side directly above the left foot area. It is very difficult to remove and even more difficult to install. I removed the flasher with a long flat tip screw driver. I installed the new flasher with two long necked socket hand drivers using the drivers to position the flasher then prying with the drivers to set the flasher in place. Good luck!!
you need a new flasher, just go to the local suto store and ask them if they have a new flasher for your turn signals
I found this site, http://installdr.com/InstallDocs/Acura/Integra.html, hope it helps.