the module is in the distributor the module is in the distributor. you will have to remove the cap and rotor. it should be held on by 2 screws. good luck
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
The engine computer is also the ignition module.
Assuming this has the 3.8 V-6 engine, the three coils are plugged into the ignition module.
3, all located ontop of the ignition control module.
2002 Audi quattro 1.8 ignition module location
A bad ignition module.
under the ignition coils. it is flat comes off after you remove the three numbered igniton coils. they plug into the module underneath them.
If you're talking about the module that's mounted on the distributer plate then Orielly's has a machine that will check it.
Part of the coil mounted to the fire wall
at coil passanger side of engine
ignition module failure or ecm failure.
ignition timing is controlled by the electronic control module or the "brain" on distributorless engines. Reysher