Why wont your blower run in your 96 gmc already replaced the relay?
Blower motor bad. Blower resistor bad. Switch bad. Fuse blown.
How to replace blower resistor in 2002 olds intrigue?
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor. ...
Asked in Heater Cores and Blower Fans
Why does the 2000 Malibu heater only work on high?
Assuming you're talking about the blower motor, because the blower motor resistor is faulty, and needs to be replaced. On the high setting, it doesn't go through the resistor - on the other settings, it does. ...
How do you diagnose a heater blower motor problem on a 2001 grand prix?
If the blower only works on high the blower resistor is most likely the problem and should be replaced. On rare occasions if the car has blown the resistor more than once the blower motor shouuld be replaced. ...
Fan blower switch for 2002 Chevy impala ac and heater only works in high position already replaced unit with new one?
Defective blower motor resistor pack.
Asked in Ford Focus, Saturn Ion
The blowers on your ford focus do not work on low speed?
heater blower resistor has to be replaced. you have to remove glove boxthe resistor is to the right of the heater blower moter ...
Asked in Chrysler Sebring
Why does the blower fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor needs to be replaced
1998 dodge stratus you replaced the blower motor resistor and your blower motor still works on high only?
replace the blower motor switch
98 dodge caravan how to replace front blower resistor?
The front blower resistor on a 98 Dodge Caravan is replaced by removing the cover and disconnecting the wiring harness. The resistor can then be pulled and a new one put in its place. ...
Asked in Mazda 626
Heater blower will not work on 1992 Mazda 626. already replaced resistor block.?
You probably need a blower motor. Check the Hot electrical feed to the motor. If you have replaced the resistor block you know where the motor is located (just to the right) It is easy to replace and can be purchased everywhere, including a junk yard. Remember some Resistor Blocks fail because the motor is old and drawing to many amps. ...
Asked in Chevy Blazer
1995 Chevy blazer heater blower will not work replaced it with a new one and it still will not work?
probably the blower motor resistor
Asked in Honda Civic LX
How do you know if the blower motor resistor is bad?
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on. ...
2001 impala does not blower motor does not work on the 1 setting?
It is either the blower motor control switch or the blower motor resistor pack. More than likely it is the resistor pack. It must be replaced or just live with it until it fails completely. ...
What can make the heaterac fan not come on when on auto or manual on a 1995 Lincoln town car Have already replaced fan and checked all fuses?
It could be the blower fan resistor or the relay
On the 2002 Nissan Maxima when the blower resistor is bad does it make a vibrating noise?
A bad blower resistor will not make a vibrating noise by itself. Carefully remove the blower resistor (under the dash at the passenger side right foot area.) check to see that it is not hitting the fan. PS a bad blower resistor usually means that the blower will only operate at high speed. Usually a small fusible link on the resistor ceramic opens. Can be replaced with a small link of unmelted solder. ...
Asked in Jeep Wrangler, Jeep Wrangler Sport
The blower in my jeep wrangler stopped working while it was on could this be a fuse problem?
It could be a blown fuse but more likely it is either the blower motor resistor or the blower switch itself. TJ's are prone to overheating and melting blower motor switches because of high current flowing through them. To test the switch, check all four fan speeds to determine which of them is inoperable. The blower motor resistor regulates the blower speed on positions 1 through 3. If the blower doesn't work on any position 1 through 3 but it works on...
Asked in Chrysler Town and Country, DIY Projects
How do you fix Chrysler town and country blower motor not shutting off?
On an auto temp system the blower motor resistor has failed and needs replaced. ...
Asked in Heater Cores and Blower Fans
Dead blower motor 2005 ram 1500 4.7L. replaced motor still dead. 12v measures good?
If you are sure that everything is working correctly then check the ground going to the blower motor assembly.............. Which goes through the blower resistor. ...
Asked in Honda Accord, Honda Accord EX, Honda Accord LX
Where is the blower resistor on a 92 Honda accord lx?
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. ...
Where is the blower motor resistor located in the rear of volkswagon Sharon?
The blower motor fan cools the resistor so the resistor is usually located close to the blower. ...
What is the problem when the fan speed only works on high for a 2008 chrysler sebring?
The blower resistor has failed. The blower resistor has failed.
Already changed the heater-air controls why won't my heater-air blower work?
have you checked the fuse if so then you will need to replace the resistor for the blower hig and low dettings have you checked the fuse do you have 12 volts to blower if so then you will need to replace the resistor for the blower replace the blower motor ...
When you replace a blower motor do you have to replace the resistor module too?
Something called a blower control module takes the place and is found in the hole where you would find a blower resistor, so there isn't a blower resistor in that vehicle. As far as the blower control module is concerned, the module is serviced as a unit. No part can be fixed or replaced. This is not to be confused with the control head in the dash. The blower control module is held into the heater box with two 8mm screws...
How do you replace blower resistor on a 2006 mustang?
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal ...