80 w90 gear oil front and rear!
replacement of the transmission dipstick tub seal on a 1994 s10 blazer
To drain the oil on a 1991 Chevy S10 Blazer, located the oil pan drain plug. Use a wrench to remove the plug and the oil will flow into the receptacle you have provided.
The front differential uses 80w90.
Inside of oil pan.
The front differential uses 80W90 gear oil.
Yes you can.
it is under the distributor.
Its in the a panel to the front of the truck, below the radiator, you need a simple slotted screwdriver to open it, very accessible from there.
Make sure it's topped off with 80 weight gear oil. But to answer your question, you diagnose the noise it's making to decide what is wrong with it.
Assuming you mean the front differential, API GL-5, viscosity SAE 80W-90 Limited-Slip Differential (LSD) gear oil. If you mean the transfer case, Dextron III/Mercon is used.
Unless you have a 4x4 or 6x6 unit, there is no front differential.
The 1987 s10 Blazer uses 4.5 quarts of oil. Make sure to check the amount using the dipstick as the amount could vary due to all of the old oil not draining completely.
time for an oil change
5W-30 in most climates.
The fuel filter is located under the drivers side door within the fuel line in front of the gas tank.if its a s10 blazer its behind a trap door in the front of truck says oil filter on door
Drain oil from oil pan, remove oil filter through access door unde raditator.
AnswerThe engine oil drain plug is located at the lowest point on the engine oil pan.
Next to the distributor
I think it is under the hood, drivers side, up front close to the radiator. It is mounted to the drivers side fender behind headlight