auxillary shaft? do you mean crankshaft od cam shaft
where to set timing for a 1988 ford ranger 2.2l
how do u change a timing belt on a 94 ford ranger need help
broken timing belt
If you mean ignition timing it will be 10 degrees BTC.
go to autozone.com, they offer online manuals with step by step repair
10 degrees BTDC ( unless engine compartment decal shows different )
No , the 2.3 liter four cylinder engine used in a 1991 Ford Ranger is NOT an interference engine ( according to the Gates website , they make timing belts etcetera )
Yes, A 1991 civic uses a timing belt, not a timing chain.
Yes , a 1991 Ford Ranger has engines that are fuel injected
The camshaft pulley mark gets lined up with the middle mark on the inside of the timing cover (you will see three raised marks. One is for retarding the timing the other is for advancing the timing. The one you want is the middle one.) The crankshaft pulley is to be at 0 degrees TOP DEAD CENTER on the compression stroke on cylinder #1. If you have a distributor that is driven by the auxillary shaft, the aux shaft pulley mark should be at the "3 o'clock" position making the distributor rotor at the #1 piston pole or close to it. Afterwards if all was correctly installed using a timing light loosen the distributor bolt and with a timing light make the engine timing 10 degrees BEFORE TOP DEAD CENTER. If you have the Distributorless Ignition System (DIS) there is no distributor and timing is not adjustable.
if it is a 4 cylinder, the cam shaft dot is straight up and the crank shaft is straight up. the dots are on the gears. easier to visit a mechanic if its a V6 with overhead cams... trust me
The 1991 Lexus ls400 has a timing belt.
Location fuse box on 1991 ford ranger
Your 1991 Mercury Topaz 2.3 liter has a timing CHAIN
Gates (they make timing belts among other items) recommends changing the timing belt on the 2.3 liter engine in your 1991 Ranger at 60,000 mile intervals if Ford doesn't have a specific recommendation . P.S. I had mine changed at 67,000 miles on my 2.3 L , but I'm not a mechanic / technician and didn't see what my old belt looked like , it was suggested that I have it done by the service writer. (salary/commission)
No, the 2003 manual transmission will not fit a 1991 Ranger.
The speakers in the doors of a 1991 Ford Ranger are 6-inch speakers.
The auxiliary fuse box is located under the passenger side knee bolster
No Belt=It has a Timing Chain.=
set timing on 1991 c2500 5.7 liter
I need to know how to install a headlight swith in a 1991 ford ranger xlt
The 1991 Ranger XLT 4.0 L does not have any airbags what so ever.
1991 Ford Ranger SLT; 4.0 V6; 5500lbs towing capacity.