Brake Fluid and Lubrication
Ford Aspire

Where does the brake fluid go in a 1996 Ford Aspire?

585960

Top Answer
User Avatar
Wiki User
Answered
2006-04-16 01:11:38
2006-04-16 01:11:38

the brake fluid goes in the brake master cylinder. it is located on the driver side in the engine compartment towards the back (firewall). it's a round black plastic lid on a light colored plastic cylinder. be sure to clean the cap off with a rag before removing it to avoid getting drit from the cap into the fluid resevoir.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Department Of Transportation ( D O T ) 3

DOT 3 brake fluid ( meeting Ford specification ESA-M6C25-A ) is used in your 1996 Ford F-150

According to the 1996 Ford Explorer Owner Guide : ( DOT 3 brake fluid ) meeting Ford specification ( ESA-M6C25-A )

For a 1996 Ford Bronco : DOT 3 brake fluid ( meeting Ford specification ESA-M6C25-A )

DOT 3 brake fluid ( meeting Ford specification ESA-M6C25-A )

For a 1996 Lincoln Town Car : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )

On a 1995 Ford Aspire : If you stand at the front of the vehicle and look in the engine compartment the automatic transaxle fluid dipstick is in the area to the LEFT of your battery ( according to a drawing I was looking at of the engine compartment of a 1996 Ford Aspire )

On a ( 1996 ) Ford Escort the brake fluid reservoir is also the clutch fluid reservoir

The ( 1996 ) Ford Aspire Owner Guide shows that Motorcraft MERCON automatic transmission fluid is used in the automatic and manual transaxles ( transmissions )

If it is like the ( 1996 ) Ford Escort : The BRAKE FLUID RESERVOIR is also the CLUTCH FLUID RESERVOIR

Motorcraft Mercon Automatic transmission fluid according to the manual ( For the automatic and the manual transaxle / transmission )

I don't know if the 1995 is the same , but the ( 1996 ) Ford Aspire uses Motorcraft MERCON automatic transmission fluid in the manual trans-axle ( manual transmission )

Department Of Transportation ( D.O.T. ) 3

Department Of Transportation ( DOT ) 3

According to the 1996 Mercury Cougar Owner Guide : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )

According to the 1996 Mercury Grand Marquis Owner Guide : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )

To put brake fluid in a 1997 Ford Explorer, you must locate the brake fluid reservoir. Once you locate it, unscrew the cap, and replenish the brake fluid.

Its hidden down next to the brake fluid resevoir

For a 1993 Ford Ranger : ( DOT 3 brake fluid )

According to the 1996 Ford F-250 owners manual : The hydraulic clutch takes ( D.O.T. 3 brake fluid , meeting Ford specification ESA-M6C25-A )

The brake fluid in a 1992 Ford Escort gets put in the brake fluid reservoir. This is normally located on the master cylinder.

The light may be the low fluid level for the master cylinder also. Check the fluid level.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.