A 1996 Chrysler Town and Country uses DOT3 brake fluid.
It is important to keep brake fluid in a car. Brake fluid is added to a 1998 Chrysler Town and Country, under the hood into the reservoir labeled 'brake fluid'.
A 1998 Chrysler Town and Country uses DOT 3 brake fluid.
A 2001 Chrysler Town and Country uses DOT 3brake fluid.
The proper fluid is DOT 3.
No but you can use atf,trany fluid
I have noticed that if the brake fluid is low enough in the brake fluid master cylinder it will cause the light to come on when turning left. before it comes on for a low fluid problem because of the fluid shifting.
The brake light switch is on a bracket just above the brake pedal.
Total transmission capacity is almost nine quarts on a 2000 Chrysler Town and Country.
Taked off the old ones and put the new ones on. Fill the brake fluid and bleed the brakes... Then take it to a brake shop and have them fix your screwed up installation.
Brake fluid is added to the brake master cylinder, under the hood on the driver side, back near the base of the windshield.
Total transmission capacity on a 2000 Chrysler Town and Country is almost nine quarts.
Master cylinder on driver's side near the firewall.
Under the hood, driver side, rear.
DOT ( 3 ) brake fluid
The brake fluid reservoir is under the hood on the driver side. The fluid is added to the master cylinder with the yellow cap back near the wiper cowl.
Red brake light most likely on due to brake fluid level/sensor issue or parking brake on/wiring issue
The brake fluid reservoir is under the hood on the driver side. It is the yellow cap back near the base of the windshield.
Pour it down the dipstick tube.
For a 1996 Lincoln Town Car : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )