There are two temp sensors on that year engine on for the gauge which is screwed into the head near the exhaust manifold and the other one is for the idiot light it is near the thermostat.
The 2.8 engine doesn't use a cam sensor.
On the engine.
The O2 sensor on a 1988 F250 is not near the engine. Go to the exhaust manifold and down the length. It is near the catalytic converter.
in the distributor in the rear of the engine. sometimes known as a hall sensor
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
Yes and its right behind the tbi
The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.
If it has a computer it is the knock sensor.
It should be on the side of the engine block over by the starter.
the oxygen sensor is grounded when you thread it into the exhaust manifold the oxygen sensor should have only 1 wire it should be purple the didnt start putting 2 or 4 wire sensors in until the early 90's there should be a ground from the battery to the block
The oxygen sensor on the 1988 ford 2.9 liter engine is located on the exhaust pipe just behind the right exhaust manifold. It screws into the exhaust pipe and has a small wire running to the tip of it. Just unplug the wire and turn out the sensor with a wrench.
The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.