answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where does the idler pulley on a 1994 Plymouth sundance go?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the starter on a 1994 Plymouth sundance?

How do I change th starter on a 1994 Plymouth sundance


Is a 1994 Plymouth sundance an interference engine?

No, it is not an interference engine.


How do you change the idler pulley on 1994 Cadillac eldorado?

Take the belt off, un-bolt the idler pulley, bolt the new pulley on, and finally put the belt back on and Viola!!


What if your Plymouth sundance 1994 code reads 3 what does it mean?

The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.


How many idler pulley does a 1994 4.9 cadillac develle has?

one


Where is the fuse for the heater blower located on a 1994 Plymouth Sundance?

in the fuse box


Where do I find An oil dipstick for a 1994 Plymouth sundance?

You can purchase a dipstick from the dealer.


What is the pulley under the alternator in a 1994 Chevy caprice 5.7L and how hard is it to change?

Are you talking about the "idler pulley"? They are quite simple to change. Loosen the serpentine belt by using a socket on the center of the tensioner pulley, slide the belt off the idler pulley, use a socket to pull the center bolt of the idler pulley and replace the pulley with a new one.


Where is the oxygen sensor on a 1994 Plymouth sundance?

It is screwed into the exhaust manifold on the rear of the engine.


How do you repair 1994 Plymouth duster speedometer cable?

A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.


Where is the camber located on your 1994 Plymouth Sundance?

Front camber is adjusted at the strut to knuckle bolts.


Why is your new idler pulley squeaking on your 1994 GM Jimmy?

I assume you mean the idler pulley on your timing assembly, if this is the case then the belt is too tight loosen tensioner pulley. if you mean the automatic tensioner pulley for your alternator and A/C and the like, the you probably need a new tensioner] Good Luck