The dual Crankshaft Position (CKP) sensor is mounted to the front of the engine, attached to an aluminum bracket mounted to the left side of the engine at the timing chain cover. A 4-wire connector plugs into the sensor, connecting it to the ignition control module.
AnswerThe crankshaft senser is located under the dampener pulley. Remove the serpentine belt. Remove right front wheel. Remove plastic access cover that's behind that wheel. With an impact wrench remove dampener pulley bolt. With an Dampener pulley puller remove pulley. There is a plastic cover that snaps in place over the senser, remove it, and you will have access to the senser.Ericthe crankshaft sensor is located behind the harmonic balancer on the ft timing cover
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
Where is a crankshaft sensor located on a nissan almera 2001
where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks
The Crankshaft Position Sensor is behind the crankshaft pulley (harmonic balancer). You will need a ½-inch drive breaker bar and appropriate socket.
The crankshaft position sensor is located at the driver's side bell housing. There are two sensors exactly alike being held with an Allen bolt. The one sensor closest to the front of the car is the speed sensor and the one closest to the rear of the car is the crankshaft position sensor. Hope that helps...
behind the harmonic balancer
where is the crankshaft sensor located on a 1988 cutlass supreme
The sensor in the distributor is the crankshaft position sensor.
Where is the crankshaft sensor located
how to replace the crankshaft position sensor located in a 2003 kia rio
Where is the crankshaft position sensor located on Audi 2002 Audi TT
crankshaft sensor is located just behind the crankshaft pulley on the front of the engine(passenger side of vehicle).
The P0336 fault code on 1997 Buick Lesabre is a fault in the crankshaft position sensor circuit.
The crankshaft position sensor is located behind the timing cover and above the crankshaft gear. the timing belt my have to be removed to access the bolts on the sensor.
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
The crankshaft sensor for this model is located at the front of the engine, near the crankshaft itself.
were is crankshaft sensor located in 2001 Saturn l300
the crankshaft sensor is located behind the crank pulley. the bottom pulley
on a 2006 nissan frontier, where is the crankshaft sensor located
Where is located the crankshaft sensor in Chevy avalanche 2002 engine 5.3?
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
The 1998 Montero Sport crankshaft sensor will be located on the rear of the engine. The crankshaft sensor is on the inside of the rear engine cover.
The rear crankshaft sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order for the sensor to be visible.