Ford Ranger
Ford Ranger XL
Ford Ranger XLT

Where exactly is the modulator valve located on a 1989 Ford Ranger Its a 2.9L 4x4?

123

Top Answer
User Avatar
Wiki User
2011-09-15 11:45:17
2011-09-15 11:45:17

on the pasenger side of the transmission in the casing towards the front of the transmission pan

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

A modulator valve is located inside the case, in front of the modulator.

User Avatar

located on the top of the transmission directly parralle from the catiletic converter

User Avatar

On your 1989 Ford Ranger : The vacuum modulator valve is on the passenger side of the A4LD automatic transmission ( it might be behind a heat shield )

User Avatar

the modulator valve does not have a screw, however, the modulator located outside the modulator valve may or may not have one.

User Avatar

The 1997 Chevrolet blazer modulator valve is located on the firewall in the engine compartment. The valve will be on the passenger side of the firewall.

User Avatar

This transmission does not have a modulator valve.This transmission does not have a modulator valve.

User Avatar

The At modulator valve is located on the side of the transmission between the transmission tunnel. you may have to lower transmission to get to it.

User Avatar

It doesn't have a modulator valve.It doesn't have a modulator valve.

User Avatar

The transmission modulator valve, On your 2006 Chevrolet Monte Carlo, is located on the top of the transmission. The valve should be labeled as such.

User Avatar

Typically, you can find the transmission modulator valve near the rear of the transmission. Its function is to control and regulate pressure.

User Avatar

I'm not a mechanic / technician but the automatic transmissions on a 2001 Ford Ranger would be electronically controlled , so there wouldn't be a modulator valve

User Avatar

it is located on transmission right hand side just above trans pan and covered by heat shield for exhaust.

User Avatar

A 1994 Plymouth does not have a modulator valve.

User Avatar

A 2000 Chevrolet Lumina has a modulator valve located on the side of the transmission. It is designed to control pressure inside the transmission and adjust shifting.

User Avatar

Your transmission is most likely a 4T60E. If so, it has no modulator valve. This transmission is electronically controlled from the ECM. Line pressure, which is what the old modulator valve controlled, is now controlled by an internal pcm solenoid.

User Avatar

No, it has an electronically controlled valve body,there is no modulator valve.

User Avatar

There is no modulator valve on the outside of this transmission.

User Avatar

The modulator valve uses hydrological pressure to shift a transmission !

User Avatar

Transmission Modulator Valve? Location=Right hand side of the transmission close to the rear .Covered by a heat shield because of the heat from the exhaust.Do not lose the pin after removal.Verify replacement modulator .Make sure it's your type.C3 transmission modulator look almost identical.Verify measurements at pin location .

User Avatar

Never heard of a modulator valve on a caravan is it for the trans? Chrysler transmisions do not have modulator valves

User Avatar

I believe it's on the passenger side of the transmission behind a heat shield

User Avatar

That transmission does not have a modulator valve on it. It is computer controlled to a point.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.