Lower rear end of engine
Where is the engine number for the volkswagen golf 1.8l 1999 model located?
Were is fuel injector located on a 1999 ford explorer
where is located the fuel injector presssure regulator on a 1999 ford explorer 5.0 liter engine?
where is the horn located on a 1999 ford explorer?
The washer fluid for the rear liftgate is supplied by the same reservoir as your windshield ( located in the engine compartment ) on a 1999 Ford Explorer
The camshaft position sensor on the 1999 4.0 L OHV engine is located at the rear of the engine block on the top of the engine where the distributor was installed on earlier versions of this engine. (according to my Haynes repair manual)
On a 1999 Ford Explorer : Bank 1 is the passenger side of the engine ( 4.0 EFI / 4.0 SOHC / 5.0 V8 )
The 4.0 L - OHV engine uses Motorcraft RT 1161 and The 4.0 L - SOHC engine uses Motorcraft RT 1160 in the 1999 Ford Explorer according to motorcraft.com
The 1992 Ford Explorer is a 4.0 liter OHV engine , in 1999 ( depending on which model and trim you have ) the 4.0 L OHV engine and the 4.0 L - SOHC - engine was used
If the 1999 Explorer is equipped with a block heater, it will be located in one of the frost plugs in the engine. It is usually placed on the side of the motor that has the most amount of room to insert the plug.
The oil pump is bolted to the bottom of the engine INSIDE the oil pan
In a 1999 Ford Explorer : The 60 amp maxi fuse in the power distribution box located in the engine compartment is for the instrument panel fuse box
Bank 1 is the passenger side of your engine on your Ford Explorer Sensor 2 is in the exhaust pipe after the catalytic converter ( downstream )
1999 FORD TRUCKS EXPLORER 5.0L 8-cyl Engine Code [P]WIX 51372 Oil Filter1999 FORD TRUCKS EXPLORER 4.0L 6-cyl Engine Code [E] SOHCWIX 51515 Oil Filter1999 FORD TRUCKS EXPLORER 4.0L 6-cyl Engine Code [X]WIX 51515 Oil Filter
Coolant recovery tank
The transmission is bolted to the rear of the engine
After the Explorer is scanned for trouble codes to diagnose and then repair the malfunction , then the check engine light can be reset
Under the hood. I suggest you research how an engine is made and what the parts are.
On a 1999 Ford Explorer : The 4.0 liter V6 engine ( Over Head Valve and Single Over Head Cam ) versions have the engine oil dipstick on the drivers side of the engine
On a 1999 Ford Explorer : The CHECK " GAGE " light ( located above your tachometer , near the " 3 " ) will come on if the gas gauge is at or near empty , the engine oil pressure is too LOW , or the engine coolant temperature is too HIGH
I'm not a mechanic / technician but I believe the camshaft position sensor on a 1999 Ford Explorer XLT , with the 4.0 liter SOHC , V6 engine is ( on the drivers side valve cover , near the engine oil fill cap )
On a 1999 Ford Explorer : In the Power Distribution Box ( which is " live " ) located in the engine compartment near the brake fluid reservoir ( the # 6 relay is the starter relay )
The spark plug gap for the 5.0 L - V8 engine - in a 1999 Ford Explorer is ( .052 - .056 inch )
Bank 2 is the drivers side of the engine in your Ford Explorer ( V6 or V8 ) Sensor 1 would be close to the engine before the exhaust enters the catalytic converter ( upstream sensor )