answersLogoWhite

0


Best Answer

Should be on the back side of the multi-function switch. Remove the upper shroud and it will be the little black box to the right of the emergency flasher button. Push it towards the front of the car and it will slide out. Anon

User Avatar

Wiki User

โˆ™ 2006-05-24 09:03:34
This answer is:
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is 2004 Chrysler sebring flasher location?
Write your answer...
Submit
Related questions

Where is the starter fuse on a 2004 Chrysler Sebring?

The 2004 Chrysler Sebring starter fuse can be found in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.


Why do the turn signals not work in a 2004 Chrysler Sebring?

If the bulbs and fuse are good, replace the turn signal Flasher Relay.


Where is oil filter location of 2004 Chrysler sebring 4 cylinder?

Behind the oil pan


Engine oil capacity of a 2004 Chrysler sebring?

2004 CHRYSLER SEBRING COUPE = 4.6 Qts W/Filter 2004 CHRYSLER SEBRING SEDAN = 5 Qts W/Filter Hope This Helps.


Flasher location on a 2004 Taurus?

Needing the location of the flasher on a 2004 Taurus


Where is the fuel pump located on a 2004 Chrysler Sebring?

The fuel pump on a Chrysler Sebring is inside the fuel tank.


Where is the diagnostic code reader location on a 2004 Chrysler Sebring?

The OBD 2 plug is located under the dash on the driver side.


Trans axle bell housing location on Chrysler sebring 2004?

The bell housing is the part of the transmission case that bolts to the engine.


Where is location of oil pressure switch on 2004 2.4L Chrysler Sebring?

is behind the engine you can reach it from the top of the engine it has 1 wire


Where is the fuse box in a 2004 Chrysler Sebring?

The 2004 Chrysler Sebring fuse box is located in the engine compartment. The fuse box will be on the drivers side behind the battery box.


What does it cost to replace a carburetor on a 2004 Chrysler Sebring?

It would be very expensive considering that car doesn't have a carburetor.


Will a 1999 Chrysler Sebring top fit a 2004?

No.


Where is Egr location on a 2004 Chrysler sebring?

The EGR valve is mounted on the rear of the engine. It is connected to two pipes, just above the bell housing.


Does a 2004 Chrysler Sebring have fuel injection?

Yes, the last Chrysler product with a carburetor was 1987.


What type of Antifreeze is required for a 2004 Chrysler Sebring?

chrysler G O 5 its yellowish


Is there a reset switch for 2004 Chrysler Sebring fuel pump If so where is it located?

No reset switches on Chrysler products.


What kind of freon do you put in a 2004 Chrysler Sebring?

R134a


What kind of oil does a 2004 Chrysler Sebring take?

5w30


Does a 2004 Chrysler Sebring have cv axles in front?

Yes


Does a 2004 Chrysler Sebring have rear ball joints?

Yes


What type of oil is needed for a 2004 Chrysler Sebring?

5w30


Does a 2004 Chrysler sebring 2.4 have an interference engine?

Yes.


Where is the emergency shut off switch on a 2004 Chrysler Sebring?

Chrysler does not use shut off switches.


What type of oil do you use in a 2004 Chrysler Sebring Coupe?

5W30


What type of oil is used in a 2004 Chrysler Sebring lx?

5w30